Electronics Forum | Wed May 26 04:51:12 EDT 2021 | starsanat
Thank you for your attention. It shows an error on startup too, so it get closed by itself. when I start it manually it shows the above mentioned errors. So I should never open up Mark3 manually right? I'll clean everything up and tell you the result
Electronics Forum | Tue Nov 20 02:26:11 EST 2018 | bukas
hello everyone, I have this problem with one of my machines. it reports EMER error code: e804 "the scale of X axis can not be detected" has anyone encountered such error before? any idea what could cause it?
Electronics Forum | Thu Aug 12 15:39:36 EDT 2021 | bukas
it can be cable. can you swap cables with next driver? also swap cables on head. if same driver shows error you need new driver probably. if new driver shows error then its cables or motor. check documentation to see what motor it drives. you cant sw
Electronics Forum | Tue May 25 12:24:17 EDT 2021 | bukas
is Mark3 program started on startup or do you start it manually? It can be like this if you run it manually. Other cause is bad contact in PCB slot or connector in 90% cases. Wash then with contact cleaner and insert and pull out few times to clean c
Electronics Forum | Thu Aug 12 06:46:35 EDT 2021 | bukas
there is no, error $0022 in technical reference. is the error you are getting a EMER level? if so there is probably a safety sensor or switch that is causing this error. $0021 is related to door switch so I would go from there. do you have technical
Electronics Forum | Fri Sep 17 16:01:03 EDT 2021 | jamesatqkits
Hi Bukas, Do you have a CP45? I need some help: Ihave no board loaded, the machine is booted and homed. So to pick up a nozzle, I open the ANC window. Click on the nozzle I want, say 29 its a CN065 When I press pick, it asks, machine is not ho
Electronics Forum | Wed Aug 11 12:41:05 EDT 2021 | jamesatqkits
Hi Bukas, Thanks for getting back to me. What is the IF board? Is that the Interface Boards in the cage? How do I know if I have a healthy hard drive? Is there anything in particular to look for? I will run chkdsk today and see if it reports any
Electronics Forum | Thu Aug 12 12:50:14 EDT 2021 | jamesatqkits
Hi Bukas, Err 22 shows up on the Panasonic motor driver in the back. I purchased this machine used. I have never had it operating in my shop. I checked the output of the transformer, 110 V output is 97 220 is 197, so I checked my input its 200 (machi
Electronics Forum | Mon Aug 30 17:21:46 EDT 2021 | jamesatqkits
So it was the drive, I was able to swap the conveyor drive for the mirror drive, these 2 drives are the same luckily. Just tapping lightly on the head would cause a 22 error to appear on the drive, at first I thought the motor must be bad. After talk
Electronics Forum | Mon May 24 05:56:59 EDT 2021 | bukas
hello James, you should be getting error message " no pneumatic pressure " when trying to get machine into READY state with no air supply. maybe you should check HDD health. while you are there, make HDD backup; and if machine uses ATA driv
.gif)
