Electronics Forum | Tue Mar 07 09:35:55 EST 2017 | buckcho
hello, I have a problem with CP45FV Neo swing > mirror. The mirror it self works fine, manually > controlled it moves to correct position and back. > While working it also moves properly but when > machine is about to check for nozzle existence a
Electronics Forum | Tue Feb 25 03:32:58 EST 2020 | bukas
hello guys, I got a problem with MAIN START switch on Samsung CP45FV NEO. The switch itself works, and it activates contactors #1-1 #1-2 and #3 but after pressing READY button there is en error msg reporting that MAIN START has not been pressed. Alre
Electronics Forum | Mon Nov 26 02:09:55 EST 2018 | bukas
yes I am, today im going to try to load backup image on to HDD. this error occurs before any machine movement, so it might be SW error... at least I hope so
Electronics Forum | Sat Jun 05 22:07:50 EDT 2021 | danniedarko
Hi, I live same error 3 years ago. I can fix this problem. but need remote access by (AnyDesk) software. and have 50USDT cost. send access information dannie.darko@outlook.com
Electronics Forum | Mon Aug 31 15:39:18 EDT 2020 | jmelson
Yes, the rightmost VME board is the IO_DPRAM, and it also handles the front panel buttons and E-stop inputs to the computer(s). So, reseat the connectors on the front of that board. Also, there may be an interface board on the bottom left (called C
Electronics Forum | Mon Aug 31 07:06:20 EDT 2020 | bukas
did you try to unslot all computer boards (both PC and machine)and put them back? sometimes they loose contact and make wacky errors...
Electronics Forum | Tue Sep 01 06:15:09 EDT 2020 | bukas
do you get error when software loads or when you run program? once i had MPU stop because there was skipped array in my step file
Electronics Forum | Wed May 26 04:51:12 EDT 2021 | starsanat
Thank you for your attention. It shows an error on startup too, so it get closed by itself. when I start it manually it shows the above mentioned errors. So I should never open up Mark3 manually right? I'll clean everything up and tell you the result
Electronics Forum | Tue Nov 20 02:26:11 EST 2018 | bukas
hello everyone, I have this problem with one of my machines. it reports EMER error code: e804 "the scale of X axis can not be detected" has anyone encountered such error before? any idea what could cause it?
Electronics Forum | Thu Aug 12 15:39:36 EDT 2021 | bukas
it can be cable. can you swap cables with next driver? also swap cables on head. if same driver shows error you need new driver probably. if new driver shows error then its cables or motor. check documentation to see what motor it drives. you cant sw
winsouce.jpg)
.gif)
