Electronics Forum | Tue May 25 12:24:17 EDT 2021 | bukas
is Mark3 program started on startup or do you start it manually? It can be like this if you run it manually. Other cause is bad contact in PCB slot or connector in 90% cases. Wash then with contact cleaner and insert and pull out few times to clean c
Electronics Forum | Wed May 26 06:07:07 EDT 2021 | bukas
its not that you should never open it manually, it just can be a problem sometimes. CP45 have a few problems with data corruption and this can be one of them. just make sure you regularly backup disk, and dont delete old backups straight away.
Electronics Forum | Thu Aug 12 06:46:35 EDT 2021 | bukas
there is no, error $0022 in technical reference. is the error you are getting a EMER level? if so there is probably a safety sensor or switch that is causing this error. $0021 is related to door switch so I would go from there. do you have technical
Electronics Forum | Wed Aug 11 12:41:05 EDT 2021 | jamesatqkits
Hi Bukas, Thanks for getting back to me. What is the IF board? Is that the Interface Boards in the cage? How do I know if I have a healthy hard drive? Is there anything in particular to look for? I will run chkdsk today and see if it reports any
Electronics Forum | Thu Aug 12 12:50:14 EDT 2021 | jamesatqkits
Hi Bukas, Err 22 shows up on the Panasonic motor driver in the back. I purchased this machine used. I have never had it operating in my shop. I checked the output of the transformer, 110 V output is 97 220 is 197, so I checked my input its 200 (machi
Electronics Forum | Mon Aug 30 17:21:46 EDT 2021 | jamesatqkits
So it was the drive, I was able to swap the conveyor drive for the mirror drive, these 2 drives are the same luckily. Just tapping lightly on the head would cause a 22 error to appear on the drive, at first I thought the motor must be bad. After talk
Electronics Forum | Fri Sep 17 16:01:03 EDT 2021 | jamesatqkits
Hi Bukas, Do you have a CP45? I need some help: Ihave no board loaded, the machine is booted and homed. So to pick up a nozzle, I open the ANC window. Click on the nozzle I want, say 29 its a CN065 When I press pick, it asks, machine is not ho
Electronics Forum | Mon May 24 05:56:59 EDT 2021 | bukas
hello James, you should be getting error message " no pneumatic pressure " when trying to get machine into READY state with no air supply. maybe you should check HDD health. while you are there, make HDD backup; and if machine uses ATA driv
Electronics Forum | Fri Dec 31 12:26:29 EST 2010 | kvael
Has any one had this problem? Dynatech says it is the I/O Dpram board, sold me one that dosen't work. Bought a second Dpram from SMTBOX, still have the same original problem. During Dpram initialization error comes up "no command response from handl
Electronics Forum | Mon Sep 13 20:30:43 EDT 2021 | jamesatqkits
Hello all, thank you to the people that have been helping me out, Hristo and Bukas. I just thought I should put this out there and see if any one can help. When I try to pick up a nozzle I get the following error: [0800] <EMER&gt
