Electronics Forum | Wed Oct 26 11:54:31 EDT 2022 | proceng1
To me, it sounds like your axis servo is losing steps. Can you get through the calibration steps? Hanwha is who we use for service. I'd say call them if you don't want to just throw parts at it.
Electronics Forum | Wed Oct 26 22:31:48 EDT 2022 | sarason
Broken wire connecting to the encoder on your servo, or anyware else in the feedback loop?, bent up encoder? sarason
Electronics Forum | Wed Oct 26 22:32:26 EDT 2022 | sarason
Broken wire connecting to the encoder on your servo, or anyware else in the feedback loop?, bent up encoder? sarason
Electronics Forum | Thu Jan 11 19:18:24 EST 2024 | madisreivik
Hello ! FUJI IP3 left head sometimes places component with rotation error. Vision processing SHOWS that component needs rotation Mechanical side is checked, looks fine. Also, changed servo, no effect. It happens randomly, maybe 1 part from 30. It
Electronics Forum | Wed Oct 26 05:44:39 EDT 2022 | spacecase
Hello all, I was looking at a Samsung SM421-f component placing machine and it's throwing up an error that was not described in the troubleshooting guide. Anytime I try to move the camera or home it the machine stops and the screen says that a skew e
Electronics Forum | Fri Jul 07 12:42:42 EDT 2023 | ttheis
We checked the three pacsci pc800 servo controllers and they all look OK, no red or error lights. VRM amps all look OK. Still haven't found the issue.
Electronics Forum | Tue Feb 27 10:34:37 EST 2024 | clpassoni
Servo motor. Maybe it's a weak encoder? This can happen? Is there any adjustment that can be made?
Electronics Forum | Fri Jul 07 17:17:43 EDT 2023 | ttheis
We swapped the Y1 and Y2 pc800 controllers with no change. We swapped out the UIMC III-I cards from another machine with no change. VRM amps all look OK, no errors. The machine moves the head both in the x and y directions during the zeroing attemp
Electronics Forum | Fri Jan 10 15:33:57 EST 2014 | hans88
Hello Rob, Thanks for your fast reply. I will check the parts you mentioned. You were right about the mot card we swaped it with a new one but that made no difference. Today we tried to find were the problem could be we: - removed the j1, j2 and
Electronics Forum | Fri Jan 12 11:04:09 EST 2007 | mika
zero > in manual Control > bring the head close to the end of the machine so that you can reach the head => Diagnostic meny > engage the clutches and THIS IS VERY IMPORTANT: use Extreme Caution (you can flip off the X-Y circuit braker on the lower ba