New Equipment | Solder Materials
Liquid Photoimageable Solder Application Since the introduction of Liquid Photoimageable Solder Masks (LPSIM) in the late 1980's, SolderMask, Inc. has continued to be the premier service-bureau applying it to PCB's. SolderMask, Inc. was the first
Industry Directory | Manufacturer's Representative
Manufacturer's representative located in Florida.
Industry News | 2018-10-18 11:08:57.0
What are PCB Thickness Options?
Electronics Forum | Thu Apr 22 10:57:20 EDT 1999 | Jack Coia
On various PCB's after building processes,such as reflow, flowsolder and wash. The soldermask on the PCB's have become discoloured, like a 'marble' effect all along the solder side of the board, it is lighter in contrast than normal, although when ot
Electronics Forum | Thu Apr 22 18:07:38 EDT 1999 | Tom B.
| On various PCB's after building processes,such as reflow, flowsolder and wash. The soldermask on the PCB's have become discoloured, like a 'marble' effect all along the solder side of the board, it is lighter in contrast than normal, although when
Electronics Forum | Thu Apr 22 13:20:04 EDT 1999 | Ben Kirk
| On various PCB's after building processes,such as reflow, flowsolder and wash. The soldermask on the PCB's have become discoloured, like a 'marble' effect all along the solder side of the board, it is lighter in contrast than normal, although when
Electronics Forum | Thu Apr 22 14:36:33 EDT 1999 | Dave F
| On various PCB's after building processes,such as reflow, flowsolder and wash. The soldermask on the PCB's have become discoloured, like a 'marble' effect all along the solder side of the board, it is lighter in contrast than normal, although when
Electronics Forum | Thu Apr 22 20:26:39 EDT 1999 | Dave F
| | On various PCB's after building processes,such as reflow, flowsolder and wash. The soldermask on the PCB's have become discoloured, like a 'marble' effect all along the solder side of the board, it is lighter in contrast than normal, although whe
Electronics Forum | Fri Jun 07 11:39:33 EDT 2019 | gregoryyork
I feared so. The only thing to be done is to tell the PCB manufacturer to increase the Thermal cure so dont set the oven to 150C but to 170C and actually measure the middle board and once it hits 155C then give it an hour cure from then. Also insist
Electronics Forum | Fri Jun 07 05:08:08 EDT 2019 | gregoryyork
Does look like delam, if its that bad and the board looks like its HASL finish or Silver, it could also be porous absorbing the chemistries of HASL or Nitric from the Silver which will greatly encourage ECM or poor SIR figures or just simply eat the
