Electronics Forum | Sun Apr 19 12:54:39 EDT 2020 | davef
A-620G doesn't require 100% wetting to the thermal pad. It requires 100% wetting to the land in the end-joint area. The end joint is the portion of the solder connection that is at the top [or bottom] of the connection. Look at 7.1.3 Solder Joint A
Electronics Forum | Fri Jun 01 13:10:23 EDT 2001 | caldon
Be current.......Is my best suggestion. Electronics Theory and three stage audio amplifiers are great for class room environment but does not 100% apply in manufacturing. Teach through hole and SMT related classes. teach manufacturing. There are tons
Electronics Forum | Sat Dec 04 09:23:20 EST 1999 | Christopher Lampron
Kantesh, Does this particular part have a heat sink across the bottom side of the component and does your pad size and stencil aperture match the component? I have just had a very similar problem with a DPAK. What we found was that the recomended pad
Electronics Forum | Tue Apr 06 09:50:58 EDT 1999 | Justin Medernach
| Does anybody put QFP's on the backsides of boards? Can they be reflowed without falling off? Do you use adhesive? | I use a double sided reflow process all day, everyday. I've hung QFP240s with embedded heat sinks and they don't fall off. Yei
Electronics Forum | Wed Aug 20 10:27:25 EDT 2003 | Dan Gosselin
Do any of you guys have a list of parts that cannot survive hanging upside down during reflow soldering. As our board designs become increasingly dense and higher speed, we need to use all available pcb real estate. This means locating parts we hi
Electronics Forum | Sun Feb 27 17:06:18 EST 2005 | Darby
This is the profile we came up with on a 1500 to satisfy the parameters suggested by Indium. This was on an FR4 1mm thick 4 layer pcb that I would descrbe as medium density, QFP, SOP, AL-CAP, TANTS, D-PAK, MINI SPRING COIL, SOT and CHIPS were all use
Electronics Forum | Thu Dec 21 02:27:57 EST 2006 | pavel_murtishev
Good morning, (1) This depends on component type. In general it would be better to have fully populated board. Or at least you should mount components with different thermal mass. You should place TC�s at three points at least: component with high t
Electronics Forum | Thu Dec 21 21:37:19 EST 2006 | Jack
Hi Pavel, Real Chunks, Thanks for your valuable inputs..Selecting the correct location for board profiling is critical in determining the solder joint quality. Am I right to say TC wire attachment locations priority should be as below: (1) Thermal
