Electronics Forum | Wed Aug 05 14:20:21 EDT 2009 | jorge_quijano
Hello there, I'm having some problems w/MPM up2000, Vision Y axis software limit error, when I tried to create a new program, appears the "Value out of range for VY BSS POS, spec 0.00 min -26.5, read 8.45" message. Any idea of how to correct this pro
Electronics Forum | Fri Feb 19 11:17:29 EST 2010 | kpm135
When I try to load a board in our MPM UP2000 HiE I get the following error "Z axis software limit". The Z axis will move up and down freely, I re-calibrated it and reprogrammed the board and the error continues. Has anyone else run into this issue an
Electronics Forum | Tue Aug 04 09:02:34 EDT 2009 | kpm135
We replaced the tactile sensor's linear actuator on a MPM Ultraprint 2000 HiE. Now we are getting a Tactile Hardware limit error every time we try to find the stencil height. I was hoping some one could explain why we're getting this error and any i
Electronics Forum | Wed May 13 10:34:57 EDT 2015 | squeekypigeon
If memory serves me right, if you are test picking a component which will be served to the machine via an LCS the 'pick position' will automatically set itself to feeder slot 1. If you change this to something more central (I used to use location 4
Electronics Forum | Wed May 06 20:52:26 EDT 2015 | arbpkevin
I have been using my topaz X for about 4 years now and I feel that I am fairly knowledgeable about it, at least the functions of it that I use... I am trying to use the LCS to place some qfp chips on a new product and I have set the whole thing up t
Electronics Forum | Wed May 13 12:39:25 EDT 2015 | arbpkevin
Ahh, yes. Just about the same time you replied someone else I asked said the same thing! I didn't realize that you had to put the part on by hand for the vision test. In the book it says to leave the feeder position set to the default setting. Fu
Electronics Forum | Thu Oct 11 00:11:49 EDT 2018 | mk15
I am looking for some help for where to look to fix this MY15E problem. We started the machine after the weekend and this error code comes. F-MOT-MSETDYN z/3: Upper end point outside limit. Any suggestions? Thanks
Electronics Forum | Wed Nov 16 09:33:39 EST 2005 | SuMoTe
I can't help you with most of that, but heres a starting point. "L013: 2nd limit over" means that one of your axis is showing outside operating boundries, as in placement head is too far forward. Make sure all your devices are not pushed out to thie
Electronics Forum | Tue Feb 12 11:26:31 EST 2019 | aldrich17
Does anyone have any info. on an "E869" error code on a Phillips Topaz X SMT machine. Error screen shows "Nozzle down limit sensor is off in A-table YV100X:N2323 YV100XT:n2223 Please check sensor and remove to the cause of this sensor being off.
Electronics Forum | Wed Feb 23 15:19:49 EST 2005 | Dilbert
I don't work on quads but I can give you some things to look for... Each of the moving axis work off a motor that is controlled by a "drive". Some of these drives have a fault or error output that is connected to the motion controller. One of your
