Electronics Forum | Mon Jan 08 01:47:35 EST 2007 | fpcb
hi to all, I have a old MPA-80 machine. I use it for simple boards without problems till now. For a more difficult board I have tried to use command "M801", I think that I have done everything right but I receive a error-message like " x(-)soft
Electronics Forum | Tue Jun 19 11:28:10 EDT 2007 | kpm135
I am fairly new to the MYData machine. The TP11 we have just started generating the following error: W-MIPR-20:System voltage BATTERY measured 14.59V (outside limits). After talking with the operators and reading the manual I believe the problem may
Electronics Forum | Wed Feb 23 22:56:46 EST 2011 | jeffr
When I enter the "Setup Table Contact" menu, then press "Load PCB" the squeegee head should move to a mid position that I can set the squeegee height, but instead it moves the squeegee head to the front limit and displays a red error message about th
Electronics Forum | Wed Nov 16 12:01:59 EST 2011 | benreben
Hi, for me the best system AOI is SAKI because is not a head with a FOV but is a scaner. this scaner take the image board in a few seconds. This machine have many algorithm for inspect all errors on a board. But the interface is difficult and the pr
Electronics Forum | Sat Oct 06 15:00:42 EDT 2012 | chrisnims
We bought a used 1999 topaz x and are trying to get it up and running. unfortunately we are getting an error: Anyone know where i can get a service manual or having any idea where to look to resolve this problem? "E229" “Nozzle down limit sensor is
Electronics Forum | Tue Nov 19 12:36:01 EST 2013 | youngbuck
DEK Infinity-Does anyone have any information on why the automatic screen changer would load the same screen in a different position everytime you load and unload? We constantly have to do a search step for the fiducial and most of the time it will e
Electronics Forum | Fri Apr 29 15:17:54 EDT 2022 | glasscake
If the machine was working appropriately before the hard drive failure i would lean on the issue being a configuration issue. Lots of machines have options in their software for different sized motors, limit sensors, IO configs, ext. See if you cant
Electronics Forum | Sat Jan 21 10:28:16 EST 2023 | compit
The so-called "drivers" are used to control each servo - control boards at the back of the machine. There are several (8?). If one is "worn out" and has no strength to move the servo, maybe this is where the error comes from? They can be interchanged
Electronics Forum | Sat Jan 21 11:39:11 EST 2023 | atpico
Thank you Michal, The MPM error messages are ambiguous to say the least and one axis not zeroing was a possible cause. But I put here what I learned again and again with this machine: when something doesn't work start by checking the fuses, all of
Electronics Forum | Mon Jul 26 10:44:08 EDT 1999 | Boca
| There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not performing