Electronics Forum | Thu Feb 05 19:45:33 EST 2004 | davef
Sure, here's one: Micro-Screen; 1106 S High St, South Bend, IN 46001; 574-232-4358 Fax: 574-234-7496; Cathy info@microscreen.org http://www.microscreen.org We list the following company in our notes, but have never used them: SEFAR AMERICA - MEC P
Electronics Forum | Sat Jan 11 17:06:27 EST 2020 | silverlead
I have worked with both Gridlock and conventional pin support mostly on DEK machines. Gridlock allows to reduce greatly changeover time in hi mix/low volume environment when switching sides on double sided boards. It also eliminates guesswork when ma
Electronics Forum | Fri Mar 21 15:54:03 EST 2003 | pjc
I heard that Minami has pulled out of the Americas. I could be wrong though. Don't know about Europa. Yes, Minami is very Japanese. Didn't see the MK-210 model, only the 280. The MPM semi-automatic models are SPM and UP100. The DEK is model 248.
Electronics Forum | Fri Jan 22 11:24:10 EST 2010 | thanh
HAVING A PROBLEM WITH DEK-248 REAR SQUEEGEES AFTER PRINT NOT COMING BACK UP. AFTER SHUT DOWN TO REBOOT, BOTH DROP DOWN,INITIALIZE MACHINE THE FRONT WORK NORMAL, THE REAR SLOWLY MOVING BACK UP, ANY ADVISE. THANKS
Electronics Forum | Tue Dec 03 07:57:27 EST 2002 | pjc
Price of DEK 248 and MPM UP100 are about the same, $22-36K range. MPM UP100 has programmable squeegee pressure. Precise, repeatable results with less operator involvement. Pressure parameters saved in board program file. DEK 248 has manual microm
Electronics Forum | Tue Oct 11 13:35:30 EDT 2016 | mnorthey
When I had this problem on the DEK 248, the problem was the table up/down sensors on the motor. You can see if there is a problem in the maintenance mode in the inputs screen. They can be adjusted by loosening off the screws and moving the sensor un
Electronics Forum | Tue Sep 05 17:38:27 EDT 2006 | flipit
I have a lot of experience on 1995 vintage Dek 248 and Dek 249. The 1995 to 1997 vintage were not the best. If Dek has improved them, great! If not, then I would not buy one. Dek 265 is a great printer. Dek did not put a lot of support into Dek
Electronics Forum | Mon Feb 14 15:14:54 EST 2000 | dean
Dek 248 / 249 (mfg'95) MPM 2000 Realignment? Are you having to insert print offsets (X.Y, theta)? If yes, your vision cubes are out of alignment. This typically happens if a "crash" occures. A "C" tool can correct this. Or are we talking abou
Electronics Forum | Mon Feb 21 18:13:23 EST 2005 | gpaelmo
As davef states above, you would like to have flat surfaces below 25 mil. We are a contract manufacturer also and we've done thousands of 15 mil QFP's with HASL finish with no problems. Your success will depend on quality of PCB supplier providing th
Electronics Forum | Fri Feb 16 05:39:56 EST 2018 | abo2016
we came across the following error this morning while working on the DEK 248 screen printer. Table in/out error message. Can we be assisted with fixing this please..
