Electronics Forum | Wed May 19 14:44:53 EDT 2004 | JSK
Low voltage readings on (PSU 2). should be: = is: +12V = 4.3V -12V = 8.6V +24V = 7.6V Anysuggestions? (Other than buying a new card.) Thanks, jsk
Electronics Forum | Mon Nov 22 11:36:32 EST 2010 | mmjm_1099
I just has this issue and replaced the MIU card. I ordered it from IBE SMT. Make sure to troubleshoot before purchasing anything of course.
Electronics Forum | Fri May 12 13:33:27 EDT 2006 | mika
...Ehhhh?? Mark Fick, If the SMT Splice Clips or Kapton tapes does not solve Your DEK-265 motor comms failure problem, maybe try this: The 5 Volts should be within +/- 0.05 V. and if I remember correctly it must Not be under 4.5 V. We have been th
Electronics Forum | Mon Feb 02 12:46:36 EST 2004 | kauer
Just a hunch, pull out and re-seat the cards. also check power supply voltage. We bought 2 used machines and one of them would not boot up, the software would just go in a loop. Turns out the 5 volt power supply was low, 4.85v. just low enough to cre
Electronics Forum | Mon Feb 02 14:30:32 EST 2004 | kauer
Could be an intermitant card, or encoder issue. Sounds like the machine is giving this error because it is loosing track of one of the axis and instead of trying to move something and possibly crash, it locks up in error mode. Could be something as s
Electronics Forum | Thu Aug 23 09:44:09 EDT 2018 | midware
Hi. Please help. On DEK 265 GSX i've got on the monitor message: "DEK 265 GSX Motor comms failure, card 1, axis 123 fatal error." F1-F8 doesn't work, machine cant start. No result after Reinitialise machine. Which one is this card1? Is it in PC?
Electronics Forum | Wed Dec 19 11:20:10 EST 2012 | aj
check for power going to the motor - trip switch at back of machine... Swap controller cards to see if the problem moves.
Electronics Forum | Fri Apr 08 09:42:31 EDT 2022 | bukas
thanks for help guys. I changed HDD and mounted image from a working machine then I ran a calibration. It still moves paste left and right but distance is much smaller so prints are acceptable. I have a spare vision card will try it tomorrow. Do I ne
Electronics Forum | Wed Dec 19 12:31:14 EST 2012 | emeto
1. Check for pins or something else under the rails. 2. Check the motor for the axis and the sensor that defines up position(I doubt it there is an encoder for this motor) 3. check card 4. check interface cable
Electronics Forum | Fri Aug 24 02:40:52 EDT 2018 | bukas
first check fuses in Y1 case. thats where EuroSYS cards are, and message you get tells you that cards can not communicate with main processing board in Y3 case via RS485. after that check cables and connectors. there are 4 EuroSYS cards in Y1 case, t
