Electronics Forum | Thu Aug 27 09:29:04 EDT 2020 | serge_pirog
Yes, I calibrated the height, no error. How can I check that pressure was compensated? If we press button "continue" after some cycles of printing system will show "error".
Electronics Forum | Fri Jan 05 10:58:43 EST 2018 | ilavu
John, I just found out more detail. If my board stop position in x is bigger than 109mm, I get error from park position to board stop.This problem started after power loss. The error comes up system power down and after pressing system button "RISIN
Electronics Forum | Thu Aug 27 14:32:34 EDT 2020 | dekhead
Following a pressure error, if continue is pressed, the next print with THE CORRESPONDING squeegee should attempt to compensate by increase or decrease in pressure (as appropriate)... Is it: 1)Not changing at all? 2)Over compensating? 3)Under compens
Electronics Forum | Fri Jan 05 03:32:46 EST 2018 | raymccomb
yes we resolved the engineer did not set the servo to zero so it did not know its datum start point.
Electronics Forum | Fri Jan 05 12:02:28 EST 2018 | ilavu
Camera works fine from home to ref. position to fiducial1 and 2. Problem shows up from home to board stop. AC voltage between AC1 and AC2 is 41.7 and during move it drops to 41.5.
Electronics Forum | Wed Nov 06 08:23:53 EST 2019 | dekhead
If it is always showing 5.0Kg as the "target" value on the error on the first print then yes there is a problem. Are you certain that it is accomplishing the requested (12Kg ?) on the prints thereafter? Does it do Heights calibration (no tools requir
Electronics Forum | Fri Aug 28 10:07:27 EDT 2020 | kylehunter
> After 2-3 cycles error disappear. Then you do not have an issue. That is the way the printer is supposed to work.
Electronics Forum | Thu Nov 07 16:02:06 EST 2019 | kylehunter
OK, got a lot of information today doing some testing.. Version number:- 07 SP11 (985 B02) Released Dec 8 2006 I did the tool(less) calibration of the squeegee height, which worked fine, no error. Did a test print, as you can see from the image, t
Electronics Forum | Wed Nov 06 06:34:26 EST 2019 | kylehunter
We have a DEK HORIZON 265 that seems to be having an issue with the pressure setting for the squeeges. It seems to have an override making the set point of the squeege pressure always be 5kg. I have it set to 12kg, but on the first print, it errors
Electronics Forum | Sat Nov 09 19:35:25 EST 2019 | richardcargill
the issue is the calibration. What you set it for has to match what it actually reads or you get the error screen at the end of every pass. If you go into the maintenance menu ( using the key next to the system button ) you can check that the pressu
