Electronics Forum | Fri May 24 03:24:14 EDT 2019 | weglimir
Thank you! it is the same on other slots as well, when I removed the board, error was the same, but it appeared instantly after DEK Program was loaded. When it is inserted - this error appears after 10 seconds (approximately) so it seems like somethi
Electronics Forum | Thu May 23 12:27:19 EDT 2019 | weglimir
Hello I have problem with card: VPM-5238D - Namely when printer starts, and DEK program initializes, it hangs for a while on "Downloading vision system" and then following error appears: "Vision Hardware Error - FATAL ERROR - REINITALIZE MACHINE" "
Electronics Forum | Tue May 28 12:56:22 EDT 2019 | dekhead
It is a communications failure between the CPU and the Cognex card. Does comms initiate between the 2 cards (flashing green on both)? or does it immediately come up red LED on Cognex? Have you reseated the CPU board as well as the Cognex? Is this a s
Electronics Forum | Thu Dec 19 07:12:41 EST 2013 | bestglobalsmt
You don't say what software version is running on > machine; generally caused by corrupted file; > delete E: config local.lpf file and then reboot > machine (new file will be created). If not this, > recommend reload of machine software (should n
Electronics Forum | Sun May 02 17:58:21 EDT 2010 | bruceb
When my DEK 265GSX boots I get a vision error1 and am asked to reinitialize. I cannot get into mainenance mode to troubleshoot. DEK told me over the phone that I have a bad Cognex card and it would be $20k to repair. This is crazy, has anyone seen th
Electronics Forum | Fri Jun 04 02:51:25 EDT 2010 | tomta
We have a DEK 265 printer currently down due to the rail system error. The message "Belt Motor Error. Rail lifted error, check tooling" pop-up when pressed run. I did remove all the support pins prior loading a new job. I also ran rail system dian
Electronics Forum | Mon Sep 20 13:55:37 EDT 2010 | jamyboy
Check to make sure that the front and back of the DEK265GSX covers are closed. I have seen issues where the back cover trips its interlock and people go other places to look for the problem.....hope this helps
Electronics Forum | Thu Apr 18 15:33:37 EDT 2013 | empac
Hello, Does anyone know how to fix the following problem on a DEK265GSX? Motor comms failure card1 AX123 Fatal error re-initialize machine. Appreciate your help! Bob
Electronics Forum | Wed Apr 27 20:32:22 EDT 2016 | sonavc
Hi, I have DEK 265GSX. Just got error message " BOARD STOP NOT RETRACTED" Any help would be greatly appreciated. Thanks
Electronics Forum | Mon Jul 30 17:08:58 EDT 2018 | erici
Thanks for your reply. I did as per your suggestion, but the problem still persists. Here is the exact error i get whenever i re-start the pc "This programme can only runa 265GS printer. This machine has been indentified as a standard 265 printer.
