Electronics Forum | Tue Nov 10 21:00:41 EST 2020 | mikewschomisch
I removed the ribbon cable from the FDD and edited the setting in SETUP to "NOT Installed";. Came back with 'Diskette drive failure on drive A'. on reboot. Still shows "Diskette error" on last line. Possible HDD issue? Thanks.
Electronics Forum | Sun Jul 18 12:13:06 EDT 2021 | oriolsancheza
Hello, Our machine started to not stopping board into the right position (stop pin was not working we guess). After some inspection we have not seen anything strange. However the DEK software decided to not work anymore. We've been messing arrounf
Electronics Forum | Thu Sep 25 09:56:23 EDT 2008 | mysmt
Hello, we are using DEK265gsx printers, at the minute ARCOM unit is not communicating with motor control cards 0,1,2,3 in Y1 enclosure. Checked CPU & RS232/485 cards from other DEK265, found okay. Any help will be appreciated. Mysmt
Electronics Forum | Fri Sep 26 07:43:55 EDT 2008 | mysmt
Hello aj, 5V & 12 V checked & present.
Electronics Forum | Fri Sep 26 12:26:16 EDT 2008 | dwelch123
Isn't that what I just said? Read it again. I said you can swap zero and one OR two and three.
Electronics Forum | Thu Sep 25 16:23:42 EDT 2008 | aj
Hi, Have you tried to download the MINT ?if this works you should be back in business , if not,check your PSU, which you can access from the back? check the manual as to which one powers the cards- dont have manual to hand but I think it is the 5v
Electronics Forum | Fri Sep 26 08:11:15 EDT 2008 | dwelch123
Try swapping cards in Y1 enclosure. You can swap zero and one or two and three but make sure you change the shunt position and the dip switch settings and see if your problem switches cards. The lithium battery likes to fail on those cards. Reload th
Electronics Forum | Thu Feb 14 13:10:58 EST 2013 | markhoch
I had this problem once a loooooooong time ago with a 248 that was at my previous place of employment. If I remember correctly, my issue was caused by a set screw on the drive gear that had worked itself loose. My issue was stright forward and quickl
Electronics Forum | Fri Sep 26 12:16:52 EDT 2008 | bickt
you cannot swap 0-3 only 0-1 or 2-3 they are not the same euro cards. they function very diffrently. if you look you will see there are more chips and circuitry on one set. there are 2 w/red leds and 2 with green leds. at least thats how they soo
Electronics Forum | Wed Dec 13 08:54:28 EST 2017 | raymccomb
We have a DEK 265 and we have fitted new belts to it after one split in use. when we set back up and run program A all is OK, when we go to run program B it has System Error. Servo Following Error - Fatal Error - Reinitialise machine. Does any one h