Electronics Forum | Thu Aug 27 14:32:34 EDT 2020 | dekhead
Following a pressure error, if continue is pressed, the next print with THE CORRESPONDING squeegee should attempt to compensate by increase or decrease in pressure (as appropriate)... Is it: 1)Not changing at all? 2)Over compensating? 3)Under compens
Electronics Forum | Sat Nov 09 19:35:25 EST 2019 | richardcargill
the issue is the calibration. What you set it for has to match what it actually reads or you get the error screen at the end of every pass. If you go into the maintenance menu ( using the key next to the system button ) you can check that the pressu
Electronics Forum | Wed Nov 06 06:34:26 EST 2019 | kylehunter
We have a DEK HORIZON 265 that seems to be having an issue with the pressure setting for the squeeges. It seems to have an override making the set point of the squeege pressure always be 5kg. I have it set to 12kg, but on the first print, it errors
Electronics Forum | Sat Nov 09 21:57:00 EST 2019 | dekhead
Not to be disagreeable, but sounds like "RichC" is describing earlier series 265 calibrations... (based upon location of PSR Amp and magnets to bypass cover interlock a 265MK1 (v. 1992-94). That "readings" calibration on your mach
Electronics Forum | Sat Nov 09 19:37:52 EST 2019 | kylehunter
> the issue is the calibration. What you set it for > has to match what it actually reads or you get > the error screen at the end of every pass. If > you go into the maintenance menu ( using the key > next to the system button )
Electronics Forum | Mon Jun 04 09:20:38 EDT 2018 | dekhead
>> mis-alignment?
Electronics Forum | Sun Nov 24 15:01:09 EST 2019 | dekhead
dekhead@att.net
Electronics Forum | Sat Nov 23 06:05:31 EST 2019 | hemantpang23
Hello Everybody, I have a problem with a DEK 265GSX, I get this error message: Vision hardware error Controlled lighting not responding FATAL ERROR - REINITIALISE MACHINE I have found that this might be due to a broken wire and I have checked all
Electronics Forum | Tue Jun 05 07:30:13 EDT 2018 | bukas
sadly no, I can't open cmd since system doesn't come up, segment display on card shows .L and 8 blinking
Electronics Forum | Mon Jun 04 09:59:03 EDT 2018 | bukas
correct, I also tried swapping motherboard but still same result. i the mean time i found battery leakage on Eurosys X1, replaced battery but now it won't start communication on machine initialization. got to repair it or something...