Electronics Forum | Mon Jun 04 10:16:29 EDT 2018 | dekhead
I have seen battery leakage damage traces on MINT cards... Since you indicate failure on machine initialization, assume you are able to communicate / accomplish MINT download. (?)
Electronics Forum | Mon Jul 16 09:15:57 EDT 2018 | bukas
problem was solved by cleaning lid bolt connector on chassis... both lid bolt and chase clamps are controlled by SCB34 card, it seams that there is an issue with poor connection on lid bolt triggering this bug. I assume its bug because other card beh
Electronics Forum | Fri Dec 20 05:44:43 EST 2019 | hemantpang23
Thanks for your reply We checked all the hardware found ok voltages are as per specifications Suspecting software issue but don't have software for installation Please confirm if you have this software version 04.03 so that we can have last try
Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas
screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st
Electronics Forum | Mon Sep 20 13:55:37 EDT 2010 | jamyboy
Check to make sure that the front and back of the DEK265GSX covers are closed. I have seen issues where the back cover trips its interlock and people go other places to look for the problem.....hope this helps
Electronics Forum | Thu Apr 18 15:33:37 EDT 2013 | empac
Hello, Does anyone know how to fix the following problem on a DEK265GSX? Motor comms failure card1 AX123 Fatal error re-initialize machine. Appreciate your help! Bob
Electronics Forum | Wed Apr 27 20:32:22 EDT 2016 | sonavc
Hi, I have DEK 265GSX. Just got error message " BOARD STOP NOT RETRACTED" Any help would be greatly appreciated. Thanks
Electronics Forum | Sun May 02 17:58:21 EDT 2010 | bruceb
When my DEK 265GSX boots I get a vision error1 and am asked to reinitialize. I cannot get into mainenance mode to troubleshoot. DEK told me over the phone that I have a bad Cognex card and it would be $20k to repair. This is crazy, has anyone seen th
Electronics Forum | Fri Jun 04 04:10:52 EDT 2010 | leeg
Have you checked the Rail Lifted Sensor
Electronics Forum | Mon Sep 20 18:25:57 EDT 2010 | dman97
Thanks for all the repiles. I finally got this machine up and running. Thanks again.