Electronics Forum | Wed Jul 17 12:00:27 EDT 2019 | weglimir
Hello, Dek printer is starting successfully until "press System switch to initialize printer" but nothing happens when I press the button. What could be the reason? I've tried another pait of monitors with different system button, and it doesn't ch
Electronics Forum | Mon Sep 20 13:43:40 EDT 2010 | dman97
Hi, Yes I dont have any estops engaged. Like I said, I can press the system switch and I can hear the locks engage, but it will not give me an option to lower the hood. I have tried turning the maintenance key, but nothing shows up on the monitor.
Electronics Forum | Mon May 03 08:09:04 EDT 2010 | Jeff
Power up your machine and look at the vision card. If it has a red light then there is a problem with it. 20k is way to much to spend to fix this. I've sent out two cards for repairs in the past and got them fixed for $2200 each. If you want more inf
Electronics Forum | Fri Feb 23 08:51:38 EST 2007 | dekhead
Are you saying that it works in "no fmi" mode, but not in manual? Please tell me how it works in both. I'm asking you to change things to ascertain the problem, not as possible solution... if you can't get the board to stop in the correct position,
Electronics Forum | Mon Sep 20 13:05:05 EDT 2010 | dman97
Hi, Yes I tried to do that. When I stick a key inside the slot, I still get a system suspended error. Although I can press the system switch and I can hear the locks engage, but nothing happens. the machine still thinks the covers are opened and
Electronics Forum | Mon Sep 20 14:15:32 EDT 2010 | dekhead
"System Suspended While Cover is Opened" indicates front or rear cover opened; not the head being raised. Therefore there is an issue with one of the cover interlocks not being made properly. Note there are 2 switches on each (NO and NC) one goes int
Electronics Forum | Mon Sep 20 14:47:59 EDT 2010 | dman97
DEKHEAD, Thanks for the repies. I have checked and re checked both cover switches, and both are making contact. I have even stuck bypass keys into both slots and still i get nothing. When you say it is an IO error, how would I go about checking t
Electronics Forum | Mon Sep 20 18:27:13 EDT 2010 | ratsalad
dman, This happened to me once on a GSX, but the head was not all the way up. I ended up shutting the machine down, inserting a bypass key so it thought the head was lowered then turning it back on. Then I told it I wanted to raise the head, hit
Electronics Forum | Fri Oct 11 03:06:00 EDT 2019 | bukas
Hello Dekhead, it is a constant offset, like 0.5 mm to right when machine prints away from operator. When print goes towards the operator there is no offset. I swapped X5 and X6 cards with spares I got but still same result . I set the program to hav
Electronics Forum | Mon Sep 03 04:05:56 EDT 2012 | omur
The issue has finally been resolved. It turns out that while checking the vision board, our engineers accidentally changed the address of the Analogue Board (which is adjacent to the vision board) - thus, leading to this startup error - with the unh