Electronics Forum | Fri Aug 28 10:07:27 EDT 2020 | kylehunter
> After 2-3 cycles error disappear. Then you do not have an issue. That is the way the printer is supposed to work.
Electronics Forum | Thu Aug 27 14:32:34 EDT 2020 | dekhead
Following a pressure error, if continue is pressed, the next print with THE CORRESPONDING squeegee should attempt to compensate by increase or decrease in pressure (as appropriate)... Is it: 1)Not changing at all? 2)Over compensating? 3)Under compens
Electronics Forum | Wed Nov 06 06:34:26 EST 2019 | kylehunter
We have a DEK HORIZON 265 that seems to be having an issue with the pressure setting for the squeeges. It seems to have an override making the set point of the squeege pressure always be 5kg. I have it set to 12kg, but on the first print, it errors
Electronics Forum | Thu Nov 07 16:02:06 EST 2019 | kylehunter
OK, got a lot of information today doing some testing.. Version number:- 07 SP11 (985 B02) Released Dec 8 2006 I did the tool(less) calibration of the squeegee height, which worked fine, no error. Did a test print, as you can see from the image, t
Electronics Forum | Sat Nov 09 19:35:25 EST 2019 | richardcargill
the issue is the calibration. What you set it for has to match what it actually reads or you get the error screen at the end of every pass. If you go into the maintenance menu ( using the key next to the system button ) you can check that the pressu
Electronics Forum | Sat Nov 09 21:57:00 EST 2019 | dekhead
Not to be disagreeable, but sounds like "RichC" is describing earlier series 265 calibrations... (based upon location of PSR Amp and magnets to bypass cover interlock a 265MK1 (v. 1992-94). That "readings" calibration on your mach
Electronics Forum | Sat Nov 09 19:37:52 EST 2019 | kylehunter
> the issue is the calibration. What you set it for > has to match what it actually reads or you get > the error screen at the end of every pass. If > you go into the maintenance menu ( using the key > next to the system button )
Electronics Forum | Sat Nov 23 06:05:31 EST 2019 | hemantpang23
Hello Everybody, I have a problem with a DEK 265GSX, I get this error message: Vision hardware error Controlled lighting not responding FATAL ERROR - REINITIALISE MACHINE I have found that this might be due to a broken wire and I have checked all
Electronics Forum | Sun Jul 18 12:13:06 EDT 2021 | oriolsancheza
Hello, Our machine started to not stopping board into the right position (stop pin was not working we guess). After some inspection we have not seen anything strange. However the DEK software decided to not work anymore. We've been messing arrounf
Electronics Forum | Tue Feb 12 01:14:46 EST 2019 | sabeti
Hello Everybody, I have a problem with a DEK 265Lt, during downloading the vision, I get this error message: Vision hardware error Controlled lighting not responding FATAL ERROR - REINITIALISE MACHINE I have found that this might be due to a broke
