Electronics Forum | Thu Feb 21 19:48:47 EST 2019 | dekhead
Is Downline FMI set to MIU? Is MIU configured (SW3) for correct interface protocol? Is downline cable pinned out correctly?
Electronics Forum | Tue Mar 02 02:52:09 EST 2021 | dekhead
I assume you are saying that the rail width doesn't initialise when you initialise machine, but when you go into diagnostics and then exit diagnostics it initialises properly. (Not sure what cycling board on belts has to do with it). Have seen, on mu
Electronics Forum | Thu Feb 13 10:38:33 EST 2003 | vortex
While trying to develop new programs for our DEK Horizon 265 we are forced to use pads as vision alignments due to lack of real fiducals, thanks engineering. My question is, Is there any way to narrow the search window when performing a locate fiduca
Electronics Forum | Sat Jan 18 18:23:15 EST 2020 | dekhead
Similar to this on Horizon i. 2 different versions used on Horizon; crank on standard chase, slider (as shown) on ASM.
Electronics Forum | Thu Jul 25 14:44:34 EDT 2013 | falvarez
Im needing an Rising table motor for Dek Horizon, but with a 4000 count encoder, because that motor i bought become with a 1000 count encoder and not worked. any suggestion?
Electronics Forum | Thu Jul 25 23:21:40 EDT 2013 | dekhead
1000ct encoder is the only one used on DEK Horizon (Typhoon Series); 2 different manufacturers, but interchangeable. http://www.dekhead.com
Electronics Forum | Fri Jan 17 09:17:49 EST 2020 | sumote
Hello all. We recently purchased a DEK Hroizon to replace our aging 265 machine. The 265 had an auto-loading stencil setting known as a "Distance To Image" where it would place the stencil directly over the board. The Horizon 2 has no such feature.
Electronics Forum | Tue Jun 03 18:49:32 EDT 2008 | edgetech
Hey, Does anyone have a calibration procedure for this machine. Thanks!
Electronics Forum | Fri Jul 26 07:21:07 EDT 2013 | falvarez
thanks!! confirmed!
Electronics Forum | Fri Jan 05 11:20:31 EST 2018 | dekhead
AC2 on MUX card).