Electronics Forum | Sat Nov 09 20:00:24 EST 2019 | richardcargill
Yeah, sorry, just noticed that bit on the photo. I'll have to have a look at my machine on Monday to see if there's anything that might explain it. The pressure system is pretty much the same on all the 265 variants so if you can find a service manua
Electronics Forum | Sat Nov 09 19:35:25 EST 2019 | richardcargill
the issue is the calibration. What you set it for has to match what it actually reads or you get the error screen at the end of every pass. If you go into the maintenance menu ( using the key next to the system button ) you can check that the pressu
Electronics Forum | Sat Nov 09 19:18:08 EST 2019 | kylehunter
Hi, I just set one of these up a month or so > ago, so it's all pretty fresh. The 265s have a > pressure sensor amplifier box that needs > calibration using the OEM calibration jig. OR you > can use a 3 quid digital luggage scale from Ebay. >
Electronics Forum | Sat Nov 09 20:08:34 EST 2019 | kylehunter
> Yeah, sorry, just noticed that bit on the > photo. I'll have to have a look at my machine on > Monday to see if there's anything that might > explain it. The pressure system is pretty much > the same on all the 265 variants so if
Electronics Forum | Sat Nov 09 19:37:52 EST 2019 | kylehunter
> the issue is the calibration. What you set it for > has to match what it actually reads or you get > the error screen at the end of every pass. If > you go into the maintenance menu ( using the key > next to the system button )
Electronics Forum | Tue Nov 10 19:20:34 EST 2020 | dekhead
Can you manually enter CMOS information in Setup and boot from there?
Electronics Forum | Tue Nov 10 19:31:09 EST 2020 | mikewschomisch
I have been able to manually enter CMOS info in SETUP thanks to suggestions from this forum and get past the CMOS and EEPROM failures. Now stuck "diskette error". Any key will produce the same message. Thanks.
Electronics Forum | Sun Jul 18 12:13:06 EDT 2021 | oriolsancheza
Hello, Our machine started to not stopping board into the right position (stop pin was not working we guess). After some inspection we have not seen anything strange. However the DEK software decided to not work anymore. We've been messing arrounf
Electronics Forum | Mon Jan 29 12:18:46 EST 2024 | oxygensmd
For low volume high mix an EKRA will be much better. Slower but much better on GUI which makes products changes faster. Operators can handle the machine easier and way better in effeciency. EKRA have really simply internal sturcture which makes servi
Electronics Forum | Tue Jan 30 15:12:56 EST 2024 | oxygensmd
We have 3 of them. E5 (2000), X5 (2006), X4 Proffessional (2012). All of them can handle our requirements, even E5 have the requested accuracy. X5 have disk PCB clamping which really nice for the operators and X4Prof have SPS (3-stage) witch pneumati
