Electronics Forum | Sat Sep 08 16:02:44 EDT 2012 | processman
hi, We have a strange issue with a DEK 265 Lt, it powers up and initialises fine. Camera LED`s flash, cognex card intitialises with no error. The issue is we have no fiducial recognition or image on the monitor. Have swapped out camera, cogn
Electronics Forum | Tue Sep 11 09:08:17 EDT 2007 | gemengr
Can not boot up . during down load vision system,an error come up VISION HARDWARE ERROR FAIL IN FUNCTION 1 STATE 2,VP STATE 0X28 ERR 0 any one know what's wrong with it.. thank you.
Electronics Forum | Sat Sep 16 15:47:08 EDT 2006 | dekhead
95% possibility to the ballscrew... which is no ones favorite to replace. As far as the table situation now. I'm guessing that you have verified that the motor has power and the brake is not engaged. Does it still give a position error? or does it g
Electronics Forum | Sat Sep 16 15:52:32 EDT 2006 | magszoo
yes we already swapped the relays and they worked fine on the second machine. How would we verify it is the ballscrew if that is a possibility?
Electronics Forum | Tue Sep 19 10:30:54 EDT 2006 | dekhead
I think you may be remembering wrong. Timer circuit will normally cause table drop when system power is re-applied, not when it is removed.
Electronics Forum | Mon May 03 08:42:12 EDT 2010 | dekhead
The $20K number thrown out there by the OEM would lead me to believe there is something else going on and/or it's the black camera vision... green/silver they usually use the $10K. DEKHEAD
Electronics Forum | Wed May 05 04:25:42 EDT 2010 | vms
We sale the cognex cards for 3500.00 all of the time, think we need to raise our prices. Right bruce? Harry
Electronics Forum | Fri Jun 04 09:31:48 EDT 2010 | thanh
there are 2 rail lift sensors at left and right of the table, maybe need to clean or re-adjust.
Electronics Forum | Mon Sep 20 12:24:18 EDT 2010 | remullis
Can you remove the interlock mechanism that makes the switch from the hood insert into the switch and trick the machine then close the hood palm down and put everything back? Some machines use magnets, some use the slotted switch with a metal key t
Electronics Forum | Mon Sep 20 13:37:09 EDT 2010 | kjs123p
Did you make sure you don't have any E-stops on?