Electronics Forum | Mon Sep 03 04:05:56 EDT 2012 | omur
The issue has finally been resolved. It turns out that while checking the vision board, our engineers accidentally changed the address of the Analogue Board (which is adjacent to the vision board) - thus, leading to this startup error - with the unh
Electronics Forum | Fri Sep 14 10:30:45 EDT 2012 | dekhead
I believe there was a software issue as well; Initially installed software (4.03) replacing existing 2.12. After that it got past the "Stack Overflow" and displayed the expected error for incorrect addressing on PCAD12... BTW solution to "vision boa
Electronics Forum | Mon Sep 20 11:58:22 EDT 2010 | dman97
Hi, I was wondering if anybody knows of a way to close the hood on a 265gsx after it has been opened and the machine has been shut down? What I’m trying to say is that the machine was shut down with the hood raised and the prop rod on. When I boot
Electronics Forum | Thu Mar 19 03:07:31 EDT 2020 | weglimir
We have DEK265 and a problem with few projects. Normally it works great, but sometimes we have an issue with Alignment out of range error. Currently we have a project where after fiducials configuration in step mode printer shows an error : Align
Electronics Forum | Sat Sep 16 16:02:19 EDT 2006 | dekhead
You are as close as you can be to verified... my 95% being an understatement... In a world (and a machine) where there are no absolutes... it's as good as it gets. I can't offer absolutes... without going over things that I might consider obvious bu
Electronics Forum | Tue Sep 19 09:27:55 EDT 2006 | vikkaraja
It has been a while since I worked on one of this machine. I recall having a similar problem where a timer was the root cause of my problem. There is a break timer in the back of the machine, it may not be staying latched. Swaped this device and kee
Electronics Forum | Mon May 03 08:09:04 EDT 2010 | Jeff
Power up your machine and look at the vision card. If it has a red light then there is a problem with it. 20k is way to much to spend to fix this. I've sent out two cards for repairs in the past and got them fixed for $2200 each. If you want more inf
Electronics Forum | Mon Sep 20 13:43:40 EDT 2010 | dman97
Hi, Yes I dont have any estops engaged. Like I said, I can press the system switch and I can hear the locks engage, but it will not give me an option to lower the hood. I have tried turning the maintenance key, but nothing shows up on the monitor.
Electronics Forum | Tue Jul 31 22:32:35 EDT 2018 | dekhead
Hardware dongle on back of machine is software key which may or may not be required for your software (depends on software version) and has nothing to do with the error you are experiencing. The hardware link to which I refer is on the Y1 backplane
Electronics Forum | Mon Sep 20 13:05:05 EDT 2010 | dman97
Hi, Yes I tried to do that. When I stick a key inside the slot, I still get a system suspended error. Although I can press the system switch and I can hear the locks engage, but nothing happens. the machine still thinks the covers are opened and
