Electronics Forum | Mon Feb 02 11:51:54 EST 2004 | jsk
error code: motor comms failure.card3, Axis123 fatal error-reinitialize machine I swapped x3 and x4, and still get the same error. Any suggestion would be greatly appreciated Thanks in advance, jsk
Electronics Forum | Wed Dec 07 22:39:03 EST 2005 | Alan
Robert, you will have to re-load the MINT software. It only takes a couple of minutes to do this. This will fix out the errors. Refer to your DEK manuals on how to carry out this function. Cheers, Alan.
Electronics Forum | Fri Feb 19 09:34:27 EST 2010 | baildl632
Thanks for the support. Maybe you can help me with another problem. I get a pate dispensor error command time out, which clears itself, then a screen actuator error command time out that doesn't clear during initialisation. Machine won't do anything
Electronics Forum | Wed May 03 08:43:51 EDT 2006 | Mark Fick
I have a DEK 265 with error code: motor comms failure.card 0, Axis123 fatal error-reinitialize machine during machine boost up I replaced new card 0 and still get the same error.I have tried to load the mint program but I cannot get program to abort
Electronics Forum | Mon Feb 02 14:30:32 EST 2004 | kauer
Could be an intermitant card, or encoder issue. Sounds like the machine is giving this error because it is loosing track of one of the axis and instead of trying to move something and possibly crash, it locks up in error mode. Could be something as s
Electronics Forum | Mon Feb 02 14:06:27 EST 2004 | jsk
I did reload mint. When i do this the machine runs fine for about 15 minutes, but i have to continue loading boards. If I let the machine idle for 3-5 minutes, i get the error. We are a low volume manufacturing company, so on a 20 piece run i will re
Electronics Forum | Wed Aug 31 08:12:37 EDT 2016 | ttheis
Search for the bios or motherboard on ebay. Type in the part numbers you find on the boards and see if anything comes up. Often these are standard pc boards. I've repaired my old MPM by finding the cards on ebay cheap.
Electronics Forum | Fri Sep 02 04:18:48 EDT 2016 | bukas
i have tested voltages on Processor board X12. all voltages are ok and stabil but +VPP (PT8 - TP9), it reads 0 volts
Electronics Forum | Wed Aug 31 07:40:58 EDT 2016 | bukas
BIOS stopped loading, now when I start machine monitor doesn't receive any signal. tried to start machine with different hard drive but nothing
Electronics Forum | Wed Aug 31 09:35:15 EDT 2016 | dekhead
Certainly possible CPU board issue; but check PC power supply, that all DCV are present and strong. www.dekhead.com
.png)
