Electronics Forum | Thu May 16 04:54:33 EDT 2013 | aj
Hi all, I have an intermittent problem on a 265 GSX printer. "Position error" on the rising table.. quite a lot of work has been done with no success. such as motor, break , encoder replaced....diagnostic checks etc.... Machine could run for a few
Electronics Forum | Tue May 27 15:11:13 EDT 2014 | dekhead
1. Rising Table Position error is, most commonly an issue of motor movement or sensor(s); Not receiving an expected input (sensor input / 'DONE' signal) in expected period of time. Try homing table in Diagnostics see if it moves and what movements ar
Electronics Forum | Mon Sep 19 11:29:33 EDT 2011 | padawanlinuxero
Hello guys ! I have a problem with a DEK 265 GSX, sometimes after download the vision or during, I get this error message: Vision hardware error Controlled lighting not responding FATAL ERROR - REINITIALISE MACHINE Now for a few weeks it gave me
Electronics Forum | Wed Mar 13 05:08:45 EDT 2013 | JB
Hello. Did you get this error fixed? I have the same problem at the moment.
Electronics Forum | Sun Sep 25 16:45:38 EDT 2011 | cbroegger
Have seen this with bad/intermittent connections to the camera. Replacing the cable fixed this.
Electronics Forum | Thu Mar 14 03:51:04 EDT 2013 | JB
Ok, got it fixed now, found a broken wire on the back of the camera
Electronics Forum | Mon Dec 14 06:26:16 EST 2015 | fredmoulin
Hi guys, I got a problem with our DEK 265 GSX : This message appears : 1300044 - Failed to perform Lighting calibration. Please, what does it mean, and how can I solve it ? Thanks very much.
Electronics Forum | Thu Sep 25 09:56:23 EDT 2008 | mysmt
Hello, we are using DEK265gsx printers, at the minute ARCOM unit is not communicating with motor control cards 0,1,2,3 in Y1 enclosure. Checked CPU & RS232/485 cards from other DEK265, found okay. Any help will be appreciated. Mysmt
Electronics Forum | Fri Sep 26 07:43:55 EDT 2008 | mysmt
Hello aj, 5V & 12 V checked & present.
Electronics Forum | Fri Sep 26 12:26:16 EDT 2008 | dwelch123
Isn't that what I just said? Read it again. I said you can swap zero and one OR two and three.