Electronics Forum | Mon Jul 16 09:15:57 EDT 2018 | bukas
problem was solved by cleaning lid bolt connector on chassis... both lid bolt and chase clamps are controlled by SCB34 card, it seams that there is an issue with poor connection on lid bolt triggering this bug. I assume its bug because other card beh
Electronics Forum | Mon Jun 04 10:16:29 EDT 2018 | dekhead
I have seen battery leakage damage traces on MINT cards... Since you indicate failure on machine initialization, assume you are able to communicate / accomplish MINT download. (?)
Electronics Forum | Tue Jun 05 07:30:13 EDT 2018 | bukas
sadly no, I can't open cmd since system doesn't come up, segment display on card shows .L and 8 blinking
Electronics Forum | Fri Dec 20 05:44:43 EST 2019 | hemantpang23
Thanks for your reply We checked all the hardware found ok voltages are as per specifications Suspecting software issue but don't have software for installation Please confirm if you have this software version 04.03 so that we can have last try
Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas
screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st
Electronics Forum | Sun Jul 18 12:13:06 EDT 2021 | oriolsancheza
Hello, Our machine started to not stopping board into the right position (stop pin was not working we guess). After some inspection we have not seen anything strange. However the DEK software decided to not work anymore. We've been messing arrounf
Electronics Forum | Tue Nov 10 19:31:09 EST 2020 | mikewschomisch
I have been able to manually enter CMOS info in SETUP thanks to suggestions from this forum and get past the CMOS and EEPROM failures. Now stuck "diskette error". Any key will produce the same message. Thanks.
Electronics Forum | Tue Nov 10 21:00:41 EST 2020 | mikewschomisch
I removed the ribbon cable from the FDD and edited the setting in SETUP to "NOT Installed";. Came back with 'Diskette drive failure on drive A'. on reboot. Still shows "Diskette error" on last line. Possible HDD issue? Thanks.
Electronics Forum | Thu Oct 29 13:55:57 EDT 2015 | edgeflex
Hi, Since we change the small best of the head carriage, the head is not going to the right positions (paste/front/rear). I could not even make a pressure test. Anyway I don't have any error message. Does somebody knows something about this and ho
Electronics Forum | Wed Nov 11 03:36:10 EST 2020 | dekhead
Assuming you have defined HDD correctly (this is a non-standard CMOS setting), unless it is a totally dead HDD not the normal error for HDD failure. More inclined to think a CPU issue, I have not seen a "bad EEPROM" on that machine before... but pres
