Electronics Forum | Fri Aug 24 02:40:52 EDT 2018 | bukas
first check fuses in Y1 case. thats where EuroSYS cards are, and message you get tells you that cards can not communicate with main processing board in Y3 case via RS485. after that check cables and connectors. there are 4 EuroSYS cards in Y1 case, t
Electronics Forum | Fri Jul 04 03:54:10 EDT 2008 | aj
Hi all, The cognex card in the GSX failed to boot up during power up. The card displays the dreaded red light on the diagnostics LED. I got a quote from Dek and I think I cold buy a 2nd user machine for the same price. So my question is - can I g
Electronics Forum | Tue Nov 10 19:46:13 EST 2020 | dekhead
Still t issue if yu remove FDD from boot sequence?
Electronics Forum | Tue Nov 10 19:20:34 EST 2020 | dekhead
Can you manually enter CMOS information in Setup and boot from there?
Electronics Forum | Mon Nov 09 15:44:39 EST 2020 | mikewschomisch
DEK 265LT displays CMOC is BAD: Restoring from EEPROM.... EEPROM is BAD: No Restore was made. You MUST run SETUP followed by LOCKMOS... FAILED Any help appreciated.
Electronics Forum | Tue Nov 10 19:31:09 EST 2020 | mikewschomisch
I have been able to manually enter CMOS info in SETUP thanks to suggestions from this forum and get past the CMOS and EEPROM failures. Now stuck "diskette error". Any key will produce the same message. Thanks.
Electronics Forum | Tue Nov 10 21:00:41 EST 2020 | mikewschomisch
I removed the ribbon cable from the FDD and edited the setting in SETUP to "NOT Installed";. Came back with 'Diskette drive failure on drive A'. on reboot. Still shows "Diskette error" on last line. Possible HDD issue? Thanks.
Electronics Forum | Wed Nov 11 03:36:10 EST 2020 | dekhead
Assuming you have defined HDD correctly (this is a non-standard CMOS setting), unless it is a totally dead HDD not the normal error for HDD failure. More inclined to think a CPU issue, I have not seen a "bad EEPROM" on that machine before... but pres
Electronics Forum | Fri Feb 09 14:28:08 EST 2024 | redspare1
Yes, I have ran into this. They won't even sell you a screw unless you give them money to "register" Trying to start for the lowest cost. I see the DEK could be harder to learn as a new person. Yes, self calibration would be great! Thanks everyone f
Electronics Forum | Tue Jul 16 16:15:14 EDT 2019 | dekhead
If a few extra seconds of cycle time won't hurt you, recommend putting at max (3.0 sec) it will cycle all the way over to the Board @ Left sensor before extending BS and reversing. Otherwise play with the timing and requirement may vary from product
winsouce.jpg)
.gif)
