Electronics Forum | Wed Aug 24 05:23:45 EDT 2016 | bukas
hello, DEK wont start and im getting this error message: motor com error, axis 1,2,3 fatal error, reinitialise machine. this happens about 30 sec after BIOSes are copied to shadow ram. euro sys cards are inserted properly and on segment display is s
Electronics Forum | Mon Jul 30 01:14:37 EDT 2018 | erici
Our DEK 265LT wont boot up with the DEK software. It says that the current version of the software can only run a 265GS printer, and to install the correct release of the software. Has anybody encountered the same problem? It just started happenin
Electronics Forum | Sun May 02 17:58:21 EDT 2010 | bruceb
When my DEK 265GSX boots I get a vision error1 and am asked to reinitialize. I cannot get into mainenance mode to troubleshoot. DEK told me over the phone that I have a bad Cognex card and it would be $20k to repair. This is crazy, has anyone seen th
Electronics Forum | Sun May 02 11:41:04 EDT 2010 | bruceb
My DEK 265GSX will not boot in the mornings. When I check my power supplies 5 volts is measuring 1.6v. When I disconnect 5v I read 5.3v on the power supply. When I reconnect to the power supply the problem goes away. Has anyone seen this problem and
Electronics Forum | Tue Sep 11 09:08:17 EDT 2007 | gemengr
Can not boot up . during down load vision system,an error come up VISION HARDWARE ERROR FAIL IN FUNCTION 1 STATE 2,VP STATE 0X28 ERR 0 any one know what's wrong with it.. thank you.
Electronics Forum | Mon Sep 20 14:11:39 EDT 2010 | dman97
Yes I have checked both covers and they are both closed. The latch keys are sitting in their respective slots. I need to know how I can lower the hood manually or if there is a way to get into the diagnostics menu before the machine boots. Thanks.
Electronics Forum | Fri Apr 19 01:42:35 EDT 2013 | dman97
Sounds like you need to run the MINT program. Boot the machine into MSDOS mode change directory to mint and type load. Let the machine auto detect the cards and re download the software to all cards.
Electronics Forum | Tue Apr 29 09:40:07 EDT 2008 | nitro
It may be a voltage issue. A very slight variance in voltage can cause this. I have seen it before with one of our machines. I think the 5vdc. was dropping out just a little bit. Turned out to be a bad muffin fan. Power supply was getting warm, 5vdc.
Electronics Forum | Wed Jun 03 06:45:38 EDT 2009 | aj
machine wont initialise after breaker tripped when machine was powered down over the weekend. All PSU's check out fine along with Estop circuit. I get the command to press system button but thats as far as it goes. any ideas welcomed
Electronics Forum | Mon Jun 04 09:59:03 EDT 2018 | bukas
correct, I also tried swapping motherboard but still same result. i the mean time i found battery leakage on Eurosys X1, replaced battery but now it won't start communication on machine initialization. got to repair it or something...
