Electronics Forum | Fri Oct 27 10:43:08 EDT 2017 | sumote
i believe someone has left a floppy disk in the drive. eject it and reboot.
Electronics Forum | Fri Oct 27 15:22:29 EDT 2017 | sumote
I defer to your superior knowledge John.
Electronics Forum | Fri Oct 27 12:00:44 EDT 2017 | dekhead
That would give "ABORT, RETRY, FAIL" message.
Electronics Forum | Fri Dec 09 02:26:31 EST 2005 | Alan.
Robert, power on the machine and go straight into DOS. You can do this by pressing and holding the Shift key as the machine is booting up. Run MINT. Try re-seating the cards too before you do this. Have you checked the voltages on the card batteries.
Electronics Forum | Mon Feb 02 12:46:36 EST 2004 | kauer
Just a hunch, pull out and re-seat the cards. also check power supply voltage. We bought 2 used machines and one of them would not boot up, the software would just go in a loop. Turns out the 5 volt power supply was low, 4.85v. just low enough to cre
Electronics Forum | Fri Feb 19 09:34:27 EST 2010 | baildl632
Thanks for the support. Maybe you can help me with another problem. I get a pate dispensor error command time out, which clears itself, then a screen actuator error command time out that doesn't clear during initialisation. Machine won't do anything
Electronics Forum | Thu Feb 21 18:43:35 EST 2019 | dekhead
Are you saying that it works in print mode and not in pass thru mode? Or that is won't pass boards downline regardless?
Electronics Forum | Thu Feb 21 19:30:32 EST 2019 | Seth
It won’t pass down regardless
Electronics Forum | Thu Feb 21 13:50:26 EST 2019 | s197seth
I am trying to do a Pass Through and the DEK wont send the board to the Conveyor and it says its waiting for downline transfer even when the SMEMAs are tripped. and on the Multi - Interface Unit, the light next to downline ready is not on. Any help?
Electronics Forum | Thu Nov 17 16:00:28 EST 2011 | nevercry14
turn on printer but canno enicialize button wont work check fuses,voltage,can there be a short any ideas.
winsouce.jpg)
.gif)
