Electronics Forum | Fri Dec 20 05:44:43 EST 2019 | hemantpang23
Thanks for your reply We checked all the hardware found ok voltages are as per specifications Suspecting software issue but don't have software for installation Please confirm if you have this software version 04.03 so that we can have last try
Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas
screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st
Electronics Forum | Thu Jun 20 10:23:47 EDT 2019 | key
Would you happen to have a picture of the RS Cylinder and Rs rail. When we send the table in sol 4 is on. When we try to send the table out sol 4 and 5 are on. We are having a hard time finding the RS Cylinder and RS rail
Electronics Forum | Fri May 24 03:24:14 EDT 2019 | weglimir
Thank you! it is the same on other slots as well, when I removed the board, error was the same, but it appeared instantly after DEK Program was loaded. When it is inserted - this error appears after 10 seconds (approximately) so it seems like somethi
Electronics Forum | Wed Feb 13 21:07:26 EST 2019 | sabeti
Hi Everybody, Appreciate if someone could help me with the above issue. Regards
Electronics Forum | Thu Feb 14 00:43:27 EST 2019 | dekhead
I sent PM to your email.
Electronics Forum | Thu Jul 30 16:27:40 EDT 2020 | michelcf
Good Day Sir. Where is the MMX?
Electronics Forum | Fri May 24 03:10:30 EDT 2019 | bukas
in my case it was contact with underboard.
Electronics Forum | Tue Feb 12 01:14:46 EST 2019 | sabeti
Hello Everybody, I have a problem with a DEK 265Lt, during downloading the vision, I get this error message: Vision hardware error Controlled lighting not responding FATAL ERROR - REINITIALISE MACHINE I have found that this might be due to a broke
Electronics Forum | Thu May 23 12:27:19 EDT 2019 | weglimir
Hello I have problem with card: VPM-5238D - Namely when printer starts, and DEK program initializes, it hangs for a while on "Downloading vision system" and then following error appears: "Vision Hardware Error - FATAL ERROR - REINITALIZE MACHINE" "