Electronics Forum | Wed Mar 13 05:08:45 EDT 2013 | JB
Hello. Did you get this error fixed? I have the same problem at the moment.
Electronics Forum | Sat Feb 11 02:50:07 EST 2023 | dekhead
Please contact me directly; DEKHEAD@ATT.NET
Electronics Forum | Tue Feb 14 05:01:29 EST 2023 | leeg
Sounds like the brake may have gone?
Electronics Forum | Fri Jun 04 02:51:25 EDT 2010 | tomta
We have a DEK 265 printer currently down due to the rail system error. The message "Belt Motor Error. Rail lifted error, check tooling" pop-up when pressed run. I did remove all the support pins prior loading a new job. I also ran rail system dian
Electronics Forum | Wed Dec 13 08:54:28 EST 2017 | raymccomb
We have a DEK 265 and we have fitted new belts to it after one split in use. when we set back up and run program A all is OK, when we go to run program B it has System Error. Servo Following Error - Fatal Error - Reinitialise machine. Does any one h
Electronics Forum | Sat Sep 06 07:23:27 EDT 2014 | gascon5383
well the camera errors didn't post. File Line Error Context File Line Error Context Line Error Context
Electronics Forum | Wed Nov 29 05:59:09 EST 2023 | leeg
We have just powered the printer on and get the following error? Anyone seen this before? DEK_CSS Service check. Timed out. Check your system configuration and restart.
Electronics Forum | Thu Feb 09 19:35:09 EST 2023 | youngbuck
Hello, We have a Dek Infinity when powering up will not initialize due to an error that says Rising Table Error (Position Error). I try to go to Diagnostics but it will not let me into anything. I press start when I'm in diagnostics and it just error
Electronics Forum | Mon Mar 06 17:42:18 EST 2017 | jswatt
Hey folks, looking for some thoughts on an error we are getting with a DEK Photon screen printer where the machine switches on and we get a DEK_CSS message - Dongle Not Found. Please connect a valid Dongle & restart the machine. the machine was work
Electronics Forum | Tue Sep 01 12:47:37 EDT 2009 | rodrigo
Hi all, Our IPII just developed yet another issue. The PCB goes in the conveyor and when in the loader, the lifter goes up and after a few seconds I get a lifter cycle alarm error. I checked the in/out screen and when I make the lifter go up, the se