Electronics Forum | Thu Feb 22 20:17:34 EST 2007 | dekhead
My guess from your description is that you're talking about the board at stop sensor (mounted on camera) that is seeing the board, but the board edge is not hitting the stopper. Either the board stop is not extending fully, or the board is sagging an
Electronics Forum | Sat Jan 11 17:06:27 EST 2020 | silverlead
I have worked with both Gridlock and conventional pin support mostly on DEK machines. Gridlock allows to reduce greatly changeover time in hi mix/low volume environment when switching sides on double sided boards. It also eliminates guesswork when ma
Electronics Forum | Wed May 31 10:39:33 EDT 2006 | grantp
Hi, We actually tried to get major parts of our line from the same supplier, however each supplier is good at some parts of the line, and not others. We went with Soltec oven and wave, which work well, and have not had any issues, plus DEK printer
Electronics Forum | Thu May 11 04:23:50 EDT 2000 | Earl Moon
Hey folks, I'm on your side, as I said many times in this string. To end it, from my point of view, I will offer the following diatribe with which I responded to one of you whom I respect very much - Dave F. This is my last say on the subject and I
Electronics Forum | Tue Jul 20 19:09:25 EDT 1999 | JohnW
| | I recently switched from solder paste in 500 gram jars to 500 gram tubes. I did this to try to limit the time the paste is exposed to the room environment. But we have a need to clean the stencil every 4 - 5 boards which means taking the bulk pas
Electronics Forum | Wed Jul 21 10:05:22 EDT 1999 | Mark Quealy
| | | I recently switched from solder paste in 500 gram jars to 500 gram tubes. I did this to try to limit the time the paste is exposed to the room environment. But we have a need to clean the stencil every 4 - 5 boards which means taking the bulk p
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
Electronics Forum | Wed Jul 21 11:49:24 EDT 1999 | Deon Nungaray
| | | | I recently switched from solder paste in 500 gram jars to 500 gram tubes. I did this to try to limit the time the paste is exposed to the room environment. But we have a need to clean the stencil every 4 - 5 boards which means taking the bulk
.png)
