Electronics Forum | Tue Sep 11 09:08:17 EDT 2007 | gemengr
Can not boot up . during down load vision system,an error come up VISION HARDWARE ERROR FAIL IN FUNCTION 1 STATE 2,VP STATE 0X28 ERR 0 any one know what's wrong with it.. thank you.
Electronics Forum | Thu Aug 30 04:40:38 EDT 2012 | menatech
could be a hardware problem (processor board, harddrive) but this overflow message is most times software related. delete the calib file for an other trial. have you the machine software for reinstall?
Electronics Forum | Mon Jul 30 17:31:59 EDT 2018 | dekhead
That error message is keyed by a hardware (soldered) link on the backplane board of the Y1 (motor controls), through direct cable to PCIB40#3... check connections both ehds; possibility of multiple PCIB failures?
Electronics Forum | Thu Aug 02 16:47:37 EDT 2018 | erici
Thanks for all your help guys. The problem ended up with the parallel port where the hardware key(dongle) was attached. The cabling from the pc to the parallel port at the back of the machine was defective. Cheers
Electronics Forum | Mon Oct 05 00:58:54 EDT 2020 | dekhead
Even worse than that, $5K for registration to have the privilege of paying another $2K for a software switch to enable the existing hardware... It is a joy!!!
Electronics Forum | Mon Oct 05 17:47:24 EDT 2020 | lesfarnacer
thanks for the idea. I checked the hardware limit and was missing only 2inch for this board. maybe with adding a metal piece 2inch long on camera stopper will work!
Electronics Forum | Fri Oct 02 13:55:58 EDT 2020 | lesfarnacer
hi , need help please with my DEK Horizon 03i , we trying to programme a longboard 600mm on the printer and board lengh on our printer is limited to 510mm . I checked on the hardware eve thing is ok but in the software we don't have the longboard op
Electronics Forum | Mon Oct 05 17:07:31 EDT 2020 | dekhead
Older machine models (Horizon / Infinity) allowed you to offset the board stop (thru crative programming) to run the larger board with parameters for the smaller board. That feature is eliminated with the Micron series. However, if you can get remote
Electronics Forum | Sun Jul 18 12:13:06 EDT 2021 | oriolsancheza
Hello, Our machine started to not stopping board into the right position (stop pin was not working we guess). After some inspection we have not seen anything strange. However the DEK software decided to not work anymore. We've been messing arrounf
Electronics Forum | Fri Oct 26 11:29:41 EDT 2001 | kaopsahl
I have two DEK 288s set up in our shop, we used to use a Fuji GSP_III. I could not possibly say enough good things about the DEKs - they are incredible. The only real complaint I have with them is that if an error pops up that locks up the software -
