Electronics Forum | Mon Oct 05 00:58:54 EDT 2020 | dekhead
Even worse than that, $5K for registration to have the privilege of paying another $2K for a software switch to enable the existing hardware... It is a joy!!!
Electronics Forum | Mon Oct 05 17:47:24 EDT 2020 | lesfarnacer
thanks for the idea. I checked the hardware limit and was missing only 2inch for this board. maybe with adding a metal piece 2inch long on camera stopper will work!
Electronics Forum | Fri Oct 02 13:55:58 EDT 2020 | lesfarnacer
hi , need help please with my DEK Horizon 03i , we trying to programme a longboard 600mm on the printer and board lengh on our printer is limited to 510mm . I checked on the hardware eve thing is ok but in the software we don't have the longboard op
Electronics Forum | Mon Oct 05 17:07:31 EDT 2020 | dekhead
Older machine models (Horizon / Infinity) allowed you to offset the board stop (thru crative programming) to run the larger board with parameters for the smaller board. That feature is eliminated with the Micron series. However, if you can get remote
Electronics Forum | Sun Jul 18 12:13:06 EDT 2021 | oriolsancheza
Hello, Our machine started to not stopping board into the right position (stop pin was not working we guess). After some inspection we have not seen anything strange. However the DEK software decided to not work anymore. We've been messing arrounf
Electronics Forum | Fri Oct 26 11:29:41 EDT 2001 | kaopsahl
I have two DEK 288s set up in our shop, we used to use a Fuji GSP_III. I could not possibly say enough good things about the DEKs - they are incredible. The only real complaint I have with them is that if an error pops up that locks up the software -
Electronics Forum | Fri Feb 05 12:25:37 EST 2010 | baildl632
Yes, it's powered up. We use a simple power supply that connects directly to the drive. It spins up fine. I belive my problem is with Windows not recognizing the old type of drive correctly. It does recognize it as a mass storage device (the drivers
Electronics Forum | Tue Aug 02 15:05:38 EDT 2011 | davef
A couple of points: * Just a nit, 'screens' fell in disuse 10-15 years ago. Old habits die slowly don't they? * Yes, DEK and MPM each hold about 50% of the solder paste printer market and about 4 or 5 others hold the rest. SOLDER PASTE PRINTER EQUI
Career Center | ORLANDO, Florida USA | Engineering,Maintenance,Production,Technical Support
Manufacturing tech/eng for a contract manufacture for 10+ years. Been working in the SMT industry for a total of 20yrs. Have done everything from operator to process work. Most familiar with Assembleon, MPM, DEK, BTU,Electrovert, SLIM-KIC, SUPER-MOLE