Electronics Forum | Mon Mar 01 22:51:05 EST 2021 | rob1
We have a DEK 265 Horizon and it exhibits a problem with conveyor belts. When I power up the DEK and try to paste boards, it fails to initialize the conveyor. I have to go into Maintenance and select cycle boards on rails. This too fails, but when I
Electronics Forum | Wed Nov 10 18:12:49 EST 2004 | dorklover664
We are looking for a new way to support PCAs in the DEK. I am trying to push for getting grid-locks but have been told they cost to much. Right now we are trying out another support system (hell if I can remember what they are called) like the grid-l
Electronics Forum | Thu Jul 25 19:18:42 EDT 2002 | lysik
I really would not compare the 2 systems. A ELA is more like MPM's UP-1500. The UP-2000 is more like the DEK Horizon or Infinity. You just opened up one of the great debates of the SMT world. MPM or DEK? You will have people on both sides defend the
Electronics Forum | Tue Jun 01 15:42:33 EDT 2004 | James
We use them on our DEK printers. They have worked out very well. The only thing we had to do was make a push down bar so we could push all the pins down and lock them. This makes setting up the blocks much easier; board is fixtured, pins released
Electronics Forum | Thu Feb 17 17:33:34 EST 2022 | mnorthey
Hi all, I have a Dek 265 Horizon that fails to print at the correct pressure. It fails pressure every pass. I am trying to Calibrate it with a PFR1200N pressure Tester which we use for our DEK 248 Printers. I am trying to build up the table height
Electronics Forum | Thu Jul 25 20:47:13 EDT 2002 | Dreamsniper
Thanks for that info... I found out that MPM has UP2000 HiE VP with price lower than DEK Horizon but just a bit higher or let's say relatively the same as DEK ELA...I find it hard to decide which among the 2 based on our budget capability. My budget
Electronics Forum | Tue Jun 05 16:12:51 EDT 2012 | kahrpr
We use both The pin placement works fine for the mpm. If its a dense board you have to to some double checking on the initial set up. On the dek we use Grid lock. For us its toss up which is better they both work.
Electronics Forum | Fri Oct 31 14:09:07 EDT 2014 | wbrenner
Having a problem with a DEK printer. In the back to front motion, getting poor ramdom paste volume on micro BGA pads. Other BGA 1 mm pads are fine. The front to back motion is fine. Any throufghts on this directional issue. Ran ~200 panels no pr
Electronics Forum | Mon Oct 03 09:19:10 EDT 2005 | John S.
We've been using Horizon 01's for a couple of years. We use the advanced 2d board and stencil to setup process control through QC-Calc. It works very well, but you must put the time into setting it up. Ask DEK if they can get you a manual for thei
Electronics Forum | Thu Oct 02 08:09:04 EDT 2008 | pwilson1
Hi All, I am currently in the process of selecting a new stencil printer and have narrowed it down to the MPM125 or DEK Horizon 03i.. We re a UK medium volume production facility running quite a high mix of double sided PCB`s. W
