Electronics Forum | Fri May 24 03:24:14 EDT 2019 | weglimir
Thank you! it is the same on other slots as well, when I removed the board, error was the same, but it appeared instantly after DEK Program was loaded. When it is inserted - this error appears after 10 seconds (approximately) so it seems like somethi
Electronics Forum | Thu May 23 12:27:19 EDT 2019 | weglimir
Hello I have problem with card: VPM-5238D - Namely when printer starts, and DEK program initializes, it hangs for a while on "Downloading vision system" and then following error appears: "Vision Hardware Error - FATAL ERROR - REINITALIZE MACHINE" "
Electronics Forum | Thu Jul 30 22:48:17 EDT 2020 | dekhead
MM (MultiMove) cards are in the M19, Motor Control, crate (located front of machine, right side). MM's are the larger cards located on the far right side; X11, X12 and X13 slots (X11 slot is only used in Infinity, empty slot on Horizon / ELA).
Electronics Forum | Thu Mar 28 08:12:19 EDT 2019 | carehawk
We had an issue where a vision cable got cut and a few wires were exposed and possibly shorted. We fixed the cable and since then have had numerous errors with the last one being pneumatic power down. We have air to the machine and have checked the p
Electronics Forum | Tue May 28 12:56:22 EDT 2019 | dekhead
It is a communications failure between the CPU and the Cognex card. Does comms initiate between the 2 cards (flashing green on both)? or does it immediately come up red LED on Cognex? Have you reseated the CPU board as well as the Cognex? Is this a s
Electronics Forum | Fri Feb 09 01:47:15 EST 2024 | erikfriesen
Added error screenshots.
Electronics Forum | Fri Feb 09 01:46:55 EST 2024 | erikfriesen
I have a 2005 DEK Horizon 02i, the cmos batt was dead, so I replaced, and reset the bios. The device hangs in initialization, eventually erroring out. The vision led's blink rapidly during this period. Also, the card shows an error in device manag
Electronics Forum | Fri Feb 09 13:51:02 EST 2024 | erikfriesen
I've looked at the logs, its error 234. Looking backwards, I see where this has happened some time ago as well.
Electronics Forum | Fri Feb 29 16:42:34 EST 2008 | vikkaraja
Hello again, Has anyone experience any problem with their vision system on the DEK machine. Machine had been running fine for at least one year without any major problem until this week. Machine's response is very slow especially the vision system. M
Electronics Forum | Fri Feb 09 19:23:31 EST 2024 | mistrthou
Excellent info. Glad ya found it.
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
