Electronics Forum | Tue Feb 09 17:24:09 EST 2021 | smtusa
I have a DEK Horizon 02i. Is it easy to swap between Squeegee and cartridge system just by installing the Proflow head assembly?
Electronics Forum | Tue Aug 22 11:25:43 EDT 2000 | Steve Thomas
Just out of curiosity, what's the maximum length print the Pro Flo is capable of? I think the Cross Flow option for the EKRAs that we use only goes up to 350mm, which is way short of what we'd need.
Electronics Forum | Fri Feb 14 02:48:55 EST 2003 | erhard
Can anyone give me informations how tell the different ProFlow systems from each other? There are casetty systems, refillable systems, refillable systems with temperature control, casette systems with software controlled pressure regulation and refil
Electronics Forum | Fri Aug 18 13:38:09 EDT 2000 | James
I've heard there might be some problems when using an enclosed print head with water soluble paste. It dries out and compacts in the head. Just the opposite of what is claimed I know, but I hear it is wonderful when using no clean paste. Can anyon
Electronics Forum | Tue Oct 24 09:35:56 EDT 2000 | Wister
Our important customer demanded us to use 12mil thick stencil,it is too difficult to release solder paste from stencil.it is not helpful even I ask stencil supplier polished the openings.The flux content is 10%. I want to ask if the polyurethane sque
Electronics Forum | Tue Jun 19 07:20:43 EDT 2007 | sami
Dear Fastek. For the Front panel board we are using multible ( 4 boards in one PCB. even thought the balance between the DEK printer and the placers still big 6 sec as a difference. But, may be this is a good idea for the main board? may be also it's
Electronics Forum | Thu Jun 14 03:45:05 EDT 2007 | erhard
Hello Sami, if your placer is faster than your printer you must have very few components on the board, how many are there? What is the tact time of your mounter for this board, what is the tact time of your printer? How large is the board, can you s
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
Electronics Forum | Fri Feb 16 09:16:19 EST 2007 | John S.
We conducted a DOE to establish our print setup parameters. These will of course depend on the paste you select, and the thing just runs. The techs store the head in a ziplock bag when not in use. When they need to run, they just attach the head,
Electronics Forum | Wed Aug 26 18:36:17 EDT 2020 | serge_pirog
Hello. Could I ask you for help. We have DEK Europa. We have changed ProFlow to squeegee head with feedback. After this during solder paste printing system shows the difference between set pressure (9 kg) and real pressure (7,5kg). I have read manual
