2.jpg)
Parts & Supplies | Pick and Place/Feeders
Supply&repair juki spare parts at l lower price: JUKI 710(720) CARRY UNIT E86127150B0 JUKI 710(720) CPU CARD E8601715AA0 JUKI 730(740) CARRY BOARD E86067210A0 JUKI 730(740) DC SERVO DRIVER E86037210A0 JUKI 750(760) AC SERVO CARD E86027210A0
Electronics Forum | Tue Mar 20 18:28:26 EDT 2018 | dekhead
Print Head Stroke Calibration?
Electronics Forum | Wed Mar 02 02:07:06 EST 2016 | mbass
3000 components per side and yes the actual print cycle is longer (13 minutes) against the DEK print stroke of 30 seconds. But overall the whole cycle time of set up etc is way less on the MY500. The ability of the machine to adjust volume of paste o
Electronics Forum | Wed Jun 29 15:42:19 EDT 2011 | dekhead
Yes it is "Print Front Limit" and "Print Rear Limit". Negative value extends the stroke, Depends on software version how useful it will be, as there are differing limits on how much you can extend the stroke. http://www.dekhead.com
Electronics Forum | Mon Nov 11 22:23:29 EST 2019 | dekhead
Pretty much paste dependent on what is required. I am not a huge fan of kneading unless absolutely necessary, so 15 minutes seems pretty short, and generally do only 2 strokes. Multiple print deposits is used when, for whatever reason you are not see
Electronics Forum | Thu Nov 03 18:20:15 EST 2005 | JG
Dek 265 GS Problem: Machine abruptly turns off. It can be in the middle of a stroke or just sitting idle. After the machine turns off we have to let it sit for a few minutes (sometimes 20) in order for it to restart. Any suggestions? Thanks in adv
Electronics Forum | Fri Aug 28 14:53:16 EDT 2020 | dekhead
It is not abnormal for the first 2-4 prints to be compensation strokes where the print pressure stablises to its set pressure, ideally the variation is
Electronics Forum | Thu Jun 16 20:29:12 EDT 2011 | dman97
Does anyone know if it is possible to change the distance that the squeegees travel? What i mean is... Is it possible to change where the squeegees start and stop during a print? Our squegees seem to stop right at the edge of the apertures and this
Electronics Forum | Sat Nov 17 11:36:16 EST 2007 | etienne
On a Dek Horizon 03 the tact time for one panel measuring 400mm print stroke took me 16 seconds at a speed of 55mm/sec. I see no reason for reducing further tact time since loading and unloading PCBs from Pick & Place machines is relatively close.
Electronics Forum | Mon Nov 11 21:44:06 EST 2019 | kylehunter
> Knead pressure, is normally at or slightly lower > (maybe 25%) than print pressure... Ahh makes sense. Couple other quick questions if you don't mind: 1) Currently do kneading after 15 mins of no activity, with 3 knead passes, is that n
