Electronics Forum | Tue Mar 20 18:28:26 EDT 2018 | dekhead
Print Head Stroke Calibration?
Electronics Forum | Thu Jun 13 20:03:05 EDT 2019 | dekhead
Does it cycle in/out in diagnostics? Have you checked pneumatics to to the RS cylinder?
Electronics Forum | Wed Jun 19 18:44:56 EDT 2019 | dekhead
Is the signal making it to the SOL? Is it toggling when signal is present? RS Cylinder is to the rear of the RS rails.
Electronics Forum | Mon Feb 01 21:39:51 EST 2021 | dekhead
Most probable is encoder feedback failure... check encoder connections.
Electronics Forum | Fri Feb 26 16:08:11 EST 2021 | dekhead
Assuming you were able to resolve. dekhead@att.net
Electronics Forum | Wed Sep 13 12:30:20 EDT 2006 | ianlg
Hi If you are looking for a good solid reliable printer you might like to compare the Dek 248 and 100MV's with the R29-V from Reprint in the UK. It has great software and vision system and is built on a new platform whereas the Dek 248 and 100MV/Mi
Electronics Forum | Sat Jan 15 16:33:13 EST 2011 | dilogic
Our DEK248 started to behave oddly - squeegee speed can't be controller anymore. It always moves with max.speeed or something close to that, regardless of the current settings. Also, the table sometimes shoots out with very high speed. I am suspectin
Electronics Forum | Fri Jun 08 15:26:17 EDT 2012 | aex
I am looking for a technician that can setup a Dek 248 in San Jose, CA sometime next week. It just needs to be set up, powered and have a quick demo of operation. Please contact me if you are able to provide this service or know someone who can. T
Electronics Forum | Thu Feb 14 10:23:32 EST 2013 | vincent_qms
Hello, we have a DEK 248 just acted up with the squeegee orror. unit powered up initiated and when throght setup a job fine but when we started printing, the back squeegee came down, touched the stencil, stay for about 5 second then came back up with
Electronics Forum | Tue Oct 11 13:35:30 EDT 2016 | mnorthey
When I had this problem on the DEK 248, the problem was the table up/down sensors on the motor. You can see if there is a problem in the maintenance mode in the inputs screen. They can be adjusted by loosening off the screws and moving the sensor un