Electronics Forum | Thu Mar 19 03:07:31 EDT 2020 | weglimir
We have DEK265 and a problem with few projects. Normally it works great, but sometimes we have an issue with Alignment out of range error. Currently we have a project where after fiducials configuration in step mode printer shows an error : Align
Electronics Forum | Mon Feb 02 14:06:27 EST 2004 | jsk
I did reload mint. When i do this the machine runs fine for about 15 minutes, but i have to continue loading boards. If I let the machine idle for 3-5 minutes, i get the error. We are a low volume manufacturing company, so on a 20 piece run i will re
Electronics Forum | Thu Oct 29 13:55:57 EDT 2015 | edgeflex
Hi, Since we change the small best of the head carriage, the head is not going to the right positions (paste/front/rear). I could not even make a pressure test. Anyway I don't have any error message. Does somebody knows something about this and ho
Electronics Forum | Mon Jul 30 17:08:58 EDT 2018 | erici
Thanks for your reply. I did as per your suggestion, but the problem still persists. Here is the exact error i get whenever i re-start the pc "This programme can only runa 265GS printer. This machine has been indentified as a standard 265 printer.
Electronics Forum | Tue Jul 31 22:32:35 EDT 2018 | dekhead
Hardware dongle on back of machine is software key which may or may not be required for your software (depends on software version) and has nothing to do with the error you are experiencing. The hardware link to which I refer is on the Y1 backplane
Electronics Forum | Wed Nov 11 03:36:10 EST 2020 | dekhead
Assuming you have defined HDD correctly (this is a non-standard CMOS setting), unless it is a totally dead HDD not the normal error for HDD failure. More inclined to think a CPU issue, I have not seen a "bad EEPROM" on that machine before... but pres
Electronics Forum | Mon Feb 02 14:30:32 EST 2004 | kauer
Could be an intermitant card, or encoder issue. Sounds like the machine is giving this error because it is loosing track of one of the axis and instead of trying to move something and possibly crash, it locks up in error mode. Could be something as s
Electronics Forum | Thu Sep 22 18:47:08 EDT 2011 | rodrigo
Hi all, We just got this machine and it is not fully functional. I read somewhere here that the folder mint has some useful stuff. I run mint and it said that it cannot communicate with card 0,1,2,3 (x1,x2,x3,x4). It said to make sure the cards are
Career Center | Wesley Chapel, Florida USA | Engineering,Management,Quality Control
15 years of experience on Electronic Manufacturing. Certified SMT Process Engineer TQM Knowledge Statistics DOE Screen Printer Thermal Process Knowledge JIT International Project Engineering Experience
