Electronics Forum | Sat Sep 16 15:52:32 EDT 2006 | magszoo
yes we already swapped the relays and they worked fine on the second machine. How would we verify it is the ballscrew if that is a possibility?
Electronics Forum | Tue Sep 19 10:30:54 EDT 2006 | dekhead
I think you may be remembering wrong. Timer circuit will normally cause table drop when system power is re-applied, not when it is removed.
Electronics Forum | Mon May 03 08:09:04 EDT 2010 | Jeff
Power up your machine and look at the vision card. If it has a red light then there is a problem with it. 20k is way to much to spend to fix this. I've sent out two cards for repairs in the past and got them fixed for $2200 each. If you want more inf
Electronics Forum | Thu Dec 13 05:30:29 EST 2012 | sunyb123
i have facing a problem in dek 265 horizon that rising table position error ,please help in for solving this problem
Electronics Forum | Sat Jun 05 09:24:40 EDT 2010 | dekhead
As stated, that error relates to rail lifted sensord (L & R)... Machine is perceiving that something is causing rails to lift at inappropriate time. You can monitor sensor status in Rising Table diagnostic to see that they are toggling appropriately.
Electronics Forum | Mon Sep 20 14:23:50 EDT 2010 | dekhead
No, there is not a way to initialise into the diagnostics menu with the head raised / covers open. Literally lowering the head manually (prop head, disconnect actuator, etc) is naturally possible, but not receommended... and based upon your symptom
Electronics Forum | Sat Sep 16 15:47:08 EDT 2006 | dekhead
95% possibility to the ballscrew... which is no ones favorite to replace. As far as the table situation now. I'm guessing that you have verified that the motor has power and the brake is not engaged. Does it still give a position error? or does it g
Electronics Forum | Wed May 03 08:43:51 EDT 2006 | Mark Fick
I have a DEK 265 with error code: motor comms failure.card 0, Axis123 fatal error-reinitialize machine during machine boost up I replaced new card 0 and still get the same error.I have tried to load the mint program but I cannot get program to abort
Electronics Forum | Mon Sep 20 13:43:40 EDT 2010 | dman97
Hi, Yes I dont have any estops engaged. Like I said, I can press the system switch and I can hear the locks engage, but it will not give me an option to lower the hood. I have tried turning the maintenance key, but nothing shows up on the monitor.
Electronics Forum | Sat Sep 16 16:02:19 EDT 2006 | dekhead
You are as close as you can be to verified... my 95% being an understatement... In a world (and a machine) where there are no absolutes... it's as good as it gets. I can't offer absolutes... without going over things that I might consider obvious bu
