Electronics Forum | Fri Dec 26 13:35:14 EST 2003 | fpcb
hi, When I start a MPA-80 ( NM 2529T ) I have a 4600 error, ( 1 block stop ) , I check the covers and the pressure : all ok. I monitor the head I/O address 012 and the relative bit 6 is responding when I open the covers. All seem ok BUT the error
Electronics Forum | Wed Dec 14 15:49:30 EST 2005 | derengmao
I did calibration for the fixed camera according to the Training Center System's book. But it seemed it is for diciding the heads'offset, very few is for camera itself. When calibrate, It does recognize the calibration tool ad finish. However when te
Electronics Forum | Mon Mar 19 23:35:10 EDT 2007 | bvdb
Hi Pete, I was using only the small and medium nozzles but it happens on both nozzles. No error message unless the delay went past about 5 seconds then a Q servo error and machine stops. Pressing reset and run enables it to continue although it th
Electronics Forum | Mon Nov 23 15:14:11 EST 2009 | bking
I recently had to change pc's because of a crash, I can't get the flexa exporter to work, it keeps coming up with the following error: Converting CAD file Error [L: 0 C: 0] Failed to acquire API library file "FlexaUnicamFxToolkitProxy.dll". Mes
Electronics Forum | Tue Jan 26 05:42:56 EST 2010 | dilogic
Our GSM1 with Flex2 heads started to generate occasional error message: "Axis head 1 theta positive lead error during move absolute command" and then stop. After palm-down it runs again for some time. Everything looks fine, so I have no idea where
Electronics Forum | Mon Sep 03 04:05:56 EDT 2012 | omur
The issue has finally been resolved. It turns out that while checking the vision board, our engineers accidentally changed the address of the Analogue Board (which is adjacent to the vision board) - thus, leading to this startup error - with the unh
Electronics Forum | Wed Dec 04 16:35:54 EST 2013 | martingruber
I am facing the following problem: Powering up the machine the start sequence stops with following message: Inizializing Hardware .... Reading SRAM data .... Inizializing MEI Motion Bd .... Mei bd. @ 240 # Dev. Version 2.4g2 Option 41 DSP BOOT MEMORY
Electronics Forum | Thu Jan 21 15:36:37 EST 2016 | brantco
I have the Error message E00900 i have checked the troubleshoot and it says to check SP1 XP6 and Y1 i have checked SP1 its ok, Relay XP6 seems ok Y1 i dont know where it is located here is the error "Air Pressure Fault" any help would be greatly
Electronics Forum | Fri May 20 12:14:25 EDT 2016 | strandy89
Im having trouble with and Ekra x5 machine. It works fine when up being run constantly, but if it sits for 10-15 minutes when you try to move the Y table to the front of the machine it makes a loud sound as if the table is hitting/catching on somethi
Electronics Forum | Mon Mar 06 17:42:18 EST 2017 | jswatt
Hey folks, looking for some thoughts on an error we are getting with a DEK Photon screen printer where the machine switches on and we get a DEK_CSS message - Dongle Not Found. Please connect a valid Dongle & restart the machine. the machine was work
.png)