Electronics Forum | Wed Jul 26 17:32:39 EDT 2017 | circustactics
Anyone familiar with the K&S 4524A Wire Bonder? I'm trying to troubleshoot an issue: It fails to save or load programs. The tool will startup with the default parameters in program 1. The parameters can be changed but attempting to save to another pr
Electronics Forum | Wed Nov 22 10:32:46 EST 2017 | itactilum
I need the soft for samsung cp40 lv + i can't find it. reinstall the s.o and I would need the soft. on the other hand it gives me an error that begins to give continuous beeps without stopping and I get the following error message "no sequence fini
Electronics Forum | Thu May 10 05:46:29 EDT 2018 | ringelgr
Hi We are using a Sony SI-F209,yesterday we encounter strange error. The machine fails to start any servo motors and we get the message shown at the attachment. Hope someone can figure it out cause we're really stuck right now. We spoke with the com
Electronics Forum | Fri Jun 26 06:32:33 EDT 2020 | dltechltd
Dear Victor, We have figured out what caused the error: One of it's MVS ICOS card had parity error (The MC reported that error too as seen in the previous pictures). We could see RED LED Light on the card, and we have pulled out, and checked: PAR_ER
Electronics Forum | Thu May 18 15:26:54 EDT 2000 | NAMCo
Yo guys - I cannot access my smtnet mailbox. I get a line error message. What gives?
Electronics Forum | Thu Mar 28 02:30:00 EST 2002 | ianchan
Hi Dave F, we tried to contact: 1) Jack Crawford, 2) Mel Parrish, but the (above supplied) links provided give error messages, is it possible to help relay this posting to them respectively for their help/review? thanks.
Electronics Forum | Tue Mar 09 22:47:26 EST 2004 | pdeuel
Contact sensors out of adjustment. If you push up on spindle the led should change state. same if spindle is pulled down. I have also had problems with PTIF error during zeroing Soft stop. last messages recieved were reported as z axis time out durin
Electronics Forum | Mon May 16 10:43:22 EDT 2005 | wizy
I would like to ask, if somebody know, what I have to do with "L3 TIME UP" error message in MPA-V, or where can I switch off the coplanarity unit?
Electronics Forum | Tue Nov 15 16:16:36 EST 2005 | bk
When it prompts for the save staus and reboots does it keep rebooting over and over? And does it come up with the error message cannot connect to MYSERV?
Electronics Forum | Fri Mar 16 16:38:15 EDT 2007 | peteb
Bert, does the hiccup happen on all four nozzles or just one? Do you get any error messages?