Electronics Forum | Thu Aug 14 03:54:59 EDT 2014 | ermani9
Failing to origin the machine. On pressing ORIGIN, it moves a small distance and gives the message "ORIGIN INCOMPLETE" and displays error ...243:Y DRIFT ADJUSTMENT NO GOOD..." Please help.
Electronics Forum | Thu Aug 13 05:28:45 EDT 2015 | dilogic
We had occasional problems and usually solve it by pulling out pogo pins slightly to extend them a bit... Also note that electric feeders have "reel empty" sensor that gives the same error message (if you are using cut tape strips without reel)
Electronics Forum | Fri Jul 21 08:42:16 EDT 2017 | davef
Try: Mycronic Inc, 320 Newburyport Turnpike, Rowley MA 01969-2002; T: +1 978 948 6919 F: +1 978 948 6915
Electronics Forum | Fri Dec 15 11:01:14 EST 2017 | robertorocco
I have one Topaz X FNC machine with this problem. The head 2 FNC not change the nozzle. The head 4-6-8 is ok and change, but head 2 no, when he tries to change the nozzle he gives me an error message. What could be the problem?
Electronics Forum | Tue Feb 06 11:48:55 EST 2018 | romford_navy
Hi Does anyone know how to change error messages coming up in Korean rather than English This has occurred after new software installation on Samsung CP40CV
Electronics Forum | Mon Jul 30 17:31:59 EDT 2018 | dekhead
That error message is keyed by a hardware (soldered) link on the backplane board of the Y1 (motor controls), through direct cable to PCIB40#3... check connections both ehds; possibility of multiple PCIB failures?
Electronics Forum | Thu Mar 21 02:52:59 EDT 2019 | bukas
looks like home sensor problem, whats the error message? does head 6 now work properly?
Electronics Forum | Fri Jul 19 11:16:21 EDT 2019 | dman97
And yes if the proper data is not correct it will give you a error message because Flexa cannot communicate with the CP6.
Electronics Forum | Tue Nov 10 19:31:09 EST 2020 | mikewschomisch
I have been able to manually enter CMOS info in SETUP thanks to suggestions from this forum and get past the CMOS and EEPROM failures. Now stuck "diskette error". Any key will produce the same message. Thanks.
Electronics Forum | Mon Nov 15 17:58:36 EST 2021 | kumarb
I just received an out of the office mail response from both. For technical support: Please call the office at +1 770 246 9706 and choose 3 for ASYS equipment or dial 4 for EKRA equipment. Please have your machine type, serial number and error mess
