Electronics Forum | Fri Dec 04 20:37:45 EST 1998 | kallol chakraborty
| | | | | Hi folks , | | | | | Lately we are seeing a lot of rawcards with black spots on the pads - most of them have Au finish(immersion gold) . We did a lot of inspecton after wave solder and found that only (fine pitch) QFP are affected the most
Electronics Forum | Tue Dec 01 09:02:18 EST 1998 | Earl Moon
| | | Hi folks , | | | Lately we are seeing a lot of rawcards with black spots on the pads - most of them have Au finish(immersion gold) . We did a lot of inspecton after wave solder and found that only (fine pitch) QFP are affected the most. Our in
Electronics Forum | Fri Dec 04 20:26:34 EST 1998 | kallol Chakraborty
| | | | Hi folks , | | | | Lately we are seeing a lot of rawcards with black spots on the pads - most of them have Au finish(immersion gold) . We did a lot of inspecton after wave solder and found that only (fine pitch) QFP are affected the most. Ou
Electronics Forum | Mon Nov 30 23:45:20 EST 1998 | Kallol Chakraborty
Hi folks , Lately we are seeing a lot of rawcards with black spots on the pads - most of them have Au finish(immersion gold) . We did a lot of inspecton after wave solder and found that only (fine pitch) QFP are affected the most. Our inspection /te
Electronics Forum | Thu May 10 19:19:41 EDT 2007 | rgduval
Wayne, I haven't seen anything indicating that Gold Immersion is necessary for lead free... However, it is my companies preferred finish for lead free assemblies. We've taken this stance for the following reasons: 1. Better solder quality on th
Electronics Forum | Fri Feb 28 11:02:06 EST 2020 | slthomas
I'm not 100% sure which type of gold you're asking about, but if you're talking about hard gold plating, I think the most common use is to provide a durable surface for things like membrane switch contacts because it resists abrasion and other mechan
Electronics Forum | Fri Feb 28 08:48:00 EST 2020 | SMTA-Joe
We've made the decision to move towards Gold Immersion on our PCBs to eliminate flatness issues with QFNs and BGAs. Land/component pad geometry, population density, and other factors, have made it necessary to ensure a near perfectly flat surface tha
Electronics Forum | Thu Aug 24 13:20:24 EDT 2000 | Murad Kurwa
One of our divisions is having this problem: - De-wetting on the smt pads and componenent termination on the bottom side after top side procssed through reflow. Board finish is immersion silver. ? Any recommendation on what we should check & verify
Electronics Forum | Tue Mar 15 07:59:07 EST 2005 | mattkehoe
We are looking for some feedback on this situation. Please let us know if you have any ideas. Thanks in advance. I have been doing some studies on defects and such with our PCB's in prep for lead free and I've come to a conclusion about our process.
Electronics Forum | Fri Aug 25 05:23:46 EDT 2000 | Wolfgang Busko
Hi Murad, like with many other questions it�s hard to judge without seeing the effect. Assuming that this site you�re talking about is well equiped with knowledge and that they handle their processes normally to everybody�s satisfaction it�s obvious
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
