Electronics Forum | Fri Jul 26 14:19:14 EDT 2019 | slthomas
Since our process engineer took off for allegedly greener pastures I've taken it upon myself to provide whatever assistance I can with the process side. In this case I'm trying to get the "2 1/2D" inspection up and running. They've never us
Electronics Forum | Tue Nov 05 06:51:59 EST 2002 | V.RAMANAND KINI
Hi, This is a widely discussed subject and since you have asked a brief explanation, I assume, you are a business man or a top executive in the company venturing in to COB. I waited to see if someone replies to you. May be it is a very old subject
Electronics Forum | Thu Jun 10 15:46:56 EDT 1999 | Chrys Shea
| Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like point-
Electronics Forum | Thu Nov 19 16:24:23 EST 1998 | Earl Moon
| Hello Everybody | | I am new to the electronics packaging arena, please be patient with me... I have a few questions regarding the various passivation used on the silicon dice. I would really appreciate if you guys could provide me with more info
Electronics Forum | Thu Oct 08 14:04:04 EDT 1998 | Kris Ewen
Manish, I've seen similar phenomenon when processing CSPs on our cards. In our case, we were placing the components over the opening to in-pad blind vias. Due to poor drilling and plating processes by our board suppliers, volatiles were outgassing
Electronics Forum | Mon Jan 24 18:41:43 EST 2005 | Chunks
Sorry Pete (and others), they do have em'. Back side of the oven. Open the doors with the power supply switch and it's right next to the power relay. Little digital ones on the Omni Flo series. Nope, our company is selling the ovens and several i
Electronics Forum | Wed Aug 04 11:01:46 EDT 2010 | ooskii
I have a question concerning what plating will go into solution during the reflow process. I am soldering a small piece of ceramic (120x180 mils 7 mil thick) onto a flex circuit. I am seeing some fractures that I am sure are being caused by handlin
Electronics Forum | Thu Dec 18 13:07:50 EST 2014 | kevinb
I have worked with Epoxy Technology in the past with silver epoxy. Just to fill you in on what I have been doing with this project in the past. I was using a silver epoxy for my 0201s. I then over molded with an epoxy with a dam and fill. Then th
Electronics Forum | Fri Aug 20 13:00:16 EDT 1999 | ScottM
| I'm trying a second time to post this very important message, to me, concerning Air-Vac's following creation. Does any own and use this stuff successfully to remove solder from 20 layer and up MLB's with .020" diameter holes? Also, is any of the ad
Electronics Forum | Thu Jun 10 21:43:18 EDT 1999 | Dean
| | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like poin
