Electronics Forum | Thu Apr 30 12:47:54 EDT 2020 | ilavu
I am looking for a software for Janome/Fisnar/Apollo Seiko JR2000(old Model) not JR2000N(new model). It is called "JR Point for Dispensing". It is old model of robot, If anyone have it and can share please? Thanks,
Electronics Forum | Wed Oct 16 10:51:35 EDT 2019 | radialvalve
Hi Joe, sorry for the delay in responding to your request, hope it's not too late. There are several questions to be answered before we can guide you to the best solution to meet your Thermal Gel Dispensing Needs. I would like the opportunity to disc
Electronics Forum | Thu Nov 11 02:59:03 EST 2004 | Base
Hi Charlie, In case you're processing large quantities of lumileds you may want to have a look at the Assembleon FS machine. It is an FCM machine of only half the length with some dedicated robots on it. In stead of all Pick&Place robots it 2 dispen
Electronics Forum | Thu Apr 26 20:18:45 EDT 2007 | hegemon
For what it is worth, we are purchasing a dispensing system including a Robotic Arm, Positive Displacement Valve (as opposed to volumetric displacement) and Controller. We have purchased this unit for doing lead free 20 mil dots at 30 mil pitch in s
Electronics Forum | Sat Jan 29 13:06:18 EST 2000 | Graham Naisbitt
Todd, All liquid coatings are Newtonian - they follow gravity so they do indeed run away from sharp leads and edges. Silicones are generally worse because they have very low surface energy - although this is an asset when trying to get under compone
Electronics Forum | Fri May 14 20:21:11 EDT 2021 | bandjwet
Thanks for the reply. We are ramping up using soldering techs and convective hand soldering. We have investigated w/many soldering robot vendors. The number of units is over 100K. We will be automating using a dispense+pick and place for greater c
Electronics Forum | Mon May 24 23:38:17 EDT 2021 | SMTA-64387687
What about dispensing SMT epoxy (cures at much lower temperatures, than solder reflow), p+p components, run through the oven to cure, and using a laser selective solder robot to solder the pads?
Electronics Forum | Sun May 12 21:06:33 EDT 2024 | ttheis
Hot melt dispenser mounted to a cobot. If you don't want to do it by hand, have a robot do it.
Electronics Forum | Mon Jun 06 09:59:47 EDT 2005 | Rob
We did the trial by dispensing (both the thermal & the electrical), but in production I would definitely use a stencil for the Conductive adhesive, as the shape, spread & volume of the adhesive is critical. (No wicking or spread) We also looked at
Electronics Forum | Thu Sep 10 17:13:31 EDT 2015 | tombstonesmt
There are factors that manufacturers have taken into consideration when dealing with coating. On/off times, dispense speeds, heights, etc.. Dedicated software with tools to easily map out paths are a godsend. We made our own coating machine with a s
A Manufacturer of High Quality, Precision, Automated Fluid Dispensing and Conformal Coating Systems, SMT Cover Tape Peel Tester and Lead Forming machines for through-hole component preparation.
611 Hollingsworth Street
Grand Junction, CO USA
Phone: (970) 245-0408
