Electronics Forum | Wed Apr 15 14:51:52 EDT 2009 | cyber_wolf
The booster was swapped. I found that I have -35 volts across pins 1 and 3 on the XWB.(measured with a scope) When I switch polarity in the software I do not get anything.(no +35V) I noticed that when I try to pulse the small X with the scope hooked
Electronics Forum | Thu Apr 16 13:23:41 EDT 2009 | bk
well by the looks of it you have pretty much replaced just about everything that could cause the problem. The only one i haven't seen is the cable going from the computer box up to the x-wagon boards. Just out of curiosity when you took your motor fr
Electronics Forum | Mon Aug 17 15:19:16 EDT 2020 | jmelson
I have a (new to me) Quad QSA-30A that I just got about a week ago. At first, I could get it to go ready most of the time, now it will never go ready. I have traced the ready button into the DPRAM board and the logic is OK all the way into one of t
Electronics Forum | Mon Jun 07 15:48:14 EDT 1999 | Tim
Thanks to all for the input. Earl's was the wackiest, what with the mention of "hollywierd" and " safe sex." Just to set the record straight, I never said we had no process controls. What I said was that I am in the middle. My factory uses one ty
Electronics Forum | Wed Aug 04 14:23:06 EDT 1999 | Dave F
| Jim McCarten and Dave F, | | Jim - How about a little explanation on your PlacePro 7100 comments? I'd like to know what a "typical SMT board" is and how "thruput is cut in half" by assembling it. Is this typical SMT board something that most manuf
Electronics Forum | Tue Sep 26 14:06:33 EDT 2006 | patrickbruneel
Jun 26, 2006 (See Comments Below) Editorial Managing the Naughty Child Mike Martel, Editor, Circuitnet I've been listening to voices on both sides of the RoHS issue and the more I hear, the more foreboding the tone becomes. Despite what some wr
Electronics Forum | Thu Sep 14 14:18:13 EDT 2006 | Kevin W. Parker
We have begun using a PCB with Organic Surface Protectant. We normally run boards with non orgainic protectant. We can wash these boards with our ultrasonic cleaner using Zestron SC202 and a separate Hot/cold rinse system with an air knife. This r
Electronics Forum | Tue Nov 05 11:52:48 EST 2019 | rgduval
Richard, Are you trying to put different pcb's on the panel, or just step and repeating the same pcb across the panel? Either way, the method is pretty similar. For step and repeat, you need to create a panel/layout, using the panel fiducials. Th
Electronics Forum | Thu Nov 05 07:54:40 EST 2009 | jeffreyj
gregp - that's the main problem I am having here: there is so little basic information available about these machines. It's almost like the sellers intentionally put as little information as possible in their listings on this site, equipmatching, etc
Electronics Forum | Thu Sep 06 22:34:15 EDT 2001 | davef
The more we talk about this, the more it seems like you should use the process we've discussed to proof your design. Immediately there after, you should use a top-flight high-mix contractor to continue the prototype run for you. If you don't have t