Electronics Forum | Thu Nov 12 09:32:30 EST 2009 | spitkis2
Take a look at http://www.atco-us.com/products/info/3 . Benchtop version is also available. A full forced convection oven delivers much better thermal uniformity than an IR/forced air combo system. When comparing different ovens, some things to
Electronics Forum | Thu Feb 24 00:37:08 EST 2022 | joshsvoboda
I have a pcb with an ENIG finish that is using a 144 pin LQFP and being soldered withSN100C/NC258 T4 paste. I used a oven profiler where the probes are taped down to the joint and the profiling software adjusts the program for the best profile for
Electronics Forum | Fri Apr 16 08:49:07 EDT 2004 | Chris Lampron
Hi Barry, Your best course of action is to perform a thermal profile and determine exactly what the times/temps are in these locations. Try to match your profile to the recommendations of your solder paste. (Time between 130-160, Time over 183 and m
Electronics Forum | Thu Nov 01 22:04:51 EDT 2007 | davef
How does the delta T on the board relate to the delta T on the component?
Electronics Forum | Wed May 14 17:56:19 EDT 2003 | bradlanger
Does anybody have any advice on how to get a decent profile out of a 4 zone IR oven? Should top heat and bottom heat be proportionate? Are there any tricks to use?
Electronics Forum | Wed Mar 16 15:52:41 EST 2005 | cyber_wolf
Are you using a standard convection reflow oven ? This does not make any sense. I have never heard of anything like this. If you are using a standard oven, then I would say that it is time to get your profiler calibrated.
Electronics Forum | Mon Feb 13 06:03:25 EST 2006 | grantp
Hi, Does it really matter what temp the oven runs at as long as the PCB's are profiled correctly? I mean we run boards through all the time to check profiles, so as long as that's ok, would it matter what the oven though the temps where? Regards,
Electronics Forum | Thu Nov 16 10:15:12 EST 2006 | SWAG
Does anyone have new info on their ROHS PCB delam. problems? We ran two profiles (different from ours) per supplier recommendations with no improvement on this problem. These profiles included a plateau or soak at 190 deg. C for 20 seconds and a sl
Electronics Forum | Thu Aug 04 08:07:51 EDT 2011 | cyber_wolf
Does anyone know of a method other than drilling holes in a board to accurately profile a BGA ?
Electronics Forum | Tue Sep 15 09:04:57 EDT 1998 | Chrys
| I was wanting to know if double sided reflow can be done with a metal plated BGA on topside. We would be running bottom side first. My boss seems to think the only way it can be done is by placing glue dots on the bottomside compoents because the
