Electronics Forum | Mon Jun 19 09:53:27 EDT 2017 | tnisbet
Hi, Yes you can add a paste dispenser to the Quad 4C. The system will dispense DOTS and DOT patterns, no lines. We sell kits to add the dispenser. It takes about 4hours to install the kit. We also sell Camalot dispensers, benchtop & floor models. w
Electronics Forum | Fri Jul 30 17:17:08 EDT 2004 | cvega
GPD Global provides a line of system to for small volume solder paste and condutive adhesive dispensing know as the MicroMax. Our systems have an accuracy of 0.001" at the needle tip, capability of two valve mountings, integrated closed loop needle
Electronics Forum | Sun Aug 01 21:17:52 EDT 2004 | Eric
I have already been working with GPD regarding this project but at the same time the stage of the project is still on the selection process so I'm still open to other machines to be qualified. As per current machine in house (Micromax II), we have
Electronics Forum | Wed Jun 15 22:27:40 EDT 2011 | pkamath2
Hello, My company recently installed a Positive Displacement Pump on a GSM Pick @ Place machine for dispensing chipbonder (loctite 3621) dots before mounting chip components. The head uses Universal stand nozzles (single port-small dot, dual port 0
Electronics Forum | Thu Jan 10 22:55:24 EST 2002 | davef
You are sure taking you sweet time getting this thing running. You're getting too much beach time. NOZZLE SELECTION Typically, the only rule of thumb that applies to choosing the correct nozzle ID is that it should be one half of the required dot d
Electronics Forum | Wed Dec 10 07:47:16 EST 2008 | benefon
If you find the correct type of adhesive/needle size then dispensing certainly is no problem. With a footed needle a very repeatable process too. Much more flexible than stencil printing and no need to mess around with stencil cleaning. But with auge
Electronics Forum | Fri Nov 09 07:29:02 EST 2001 | henriksn
Hi, I would just like to add, that in our prototype production we often mount doublesided pcb's with components ranging from 0402 to BGA-280 to QFP-100. Of course we also mount and solder the side with the BGA's and QFP's last. Like the others here,
Electronics Forum | Sat Mar 30 17:27:45 EST 2002 | davef
You should not have glue "all over the place." Tou should not have glue on solderable surfaces. It sounds like you are stringing glue from one dispense location to the next. Search the fine SMTnet Archives [there might be something there]. Read a
Electronics Forum | Thu Dec 11 04:25:06 EST 2008 | lconnor
I have previously experienced dispensing glue dots using a camalot system. This was used to dispense dots for a variety of components, as the SMT was applied post through hole and then wave soldered. No paste was used in the process. The other benefi
Electronics Forum | Wed May 26 01:24:58 EDT 2004 | Adam
Hi Can anyone tell on how to go about creating an SPC chart for monitoring and measuring dispensed glue dots ? Thanks Adam
.gif)
.png)
