Electronics Forum | Mon Jan 24 04:26:32 EST 2005 | Hannu
Morning all, Has anybody done any pin in paste job with a dispenser? I read somewhere that the needle i.d. should be slightly larger than the hole diameter, but with holes of 1.4 mm I would have to work with a very large needle indeed. How does past
Electronics Forum | Thu Jun 24 12:02:59 EDT 2004 | russ
I have never done these components before, but if you have performed capability studies on your dispense equipment you should be able to tell if this is feasable. I can tell you that 0402 and 0201 especially 0201 requires great accuracy and volume.
Electronics Forum | Sat Jul 10 12:18:10 EDT 1999 | Steve
| Has anybody successfully used an automated dispensing system to put solder paste dots on .5 mm pitch pads?? I need to replace some Meritec tsop sockets and I don't want to use the single site stencils for .5 mm parts. | Try http://www.winslowaut
Electronics Forum | Mon May 19 17:17:41 EDT 2003 | JB
We currently use a Universal GDM for our glue dispensing applications, piston pumps. My question is: Have you had any problems with air getting in the dispense system that will cause missing dots? If so, how have you approached to this problem? Int
Electronics Forum | Tue Jan 31 08:59:24 EST 2017 | rob
Hi Joshua, We ran 150K per week this way, you just need a lot of pallets. Regarding dispensing I've seen 0201 (Imperial)paste dispensed, so about 0.4ish mm dots. I'm sure the Mydata printer is also pretty high resolution too, but not too quick.
Electronics Forum | Mon Jun 19 12:42:16 EDT 2023 | daniel_stanphill
The my700 can dispense 1 million dots per hour. It's not an exaggeration either. It literally never stops moving, and is dispensing without contacting the board. It uses the same type of mathematical calculations that a plane dropping a bomb uses in
Electronics Forum | Thu Sep 30 03:33:58 EDT 2004 | pioneertechnology
Hi All We have two boards that we produce which are chip on glue. For this we use KME BD12's which use air to dispense the glue dot on to the board. This is not ideal as the glue dot size differs as we go down the tube causing us quality problems.
Electronics Forum | Wed Mar 31 14:30:11 EST 1999 | Dave F
| We have carried out some experimental work, in conjunction with DEK. Instead of dispensing adhesive for SMD components onto the bottom side of on of our PCBs, we have looked at the possibility of screen printing the adhesive. Because, at the stage
Electronics Forum | Tue Mar 07 15:11:43 EST 2006 | davef
We wouldn't know a Gemini from a bread box, nor we are real clear on what you seek. So, we'll just rattle on for a while. Here's how we monitor the quality of our dispensing process: * We dispense the same nonfunctional pattern of dots on every boa
Electronics Forum | Wed Apr 08 15:47:07 EDT 1998 | Ron Beasley
| | Any one have any experience with or knowledge of the Panasonic HDP-G1 adhesive dispenser, or any other Panasonic dispensers. | Ron, | I have used this piece of equipment and I'll tell you what I tell everybody else about it. I don't trust it. T
