Electronics Forum | Wed Mar 27 05:48:32 EST 2002 | ianchan
thanks for the opinion, dun think we want to drill the machine tables, due to SMT line config : 1) printer, 1unit machine 2) chip shooters, 3 units machine 3) IC mounter, 1 unit machine plus the potential void of machine warranty by the drilling,
Electronics Forum | Tue Aug 01 12:16:10 EDT 2006 | Vernon
Had a similar problem on a high speed drilling machine. It took 1 month before I found it. In the leadscrew ball nut, there was a guide tube which the balls circulate through. at the end of the tube is a shaped lip. This lip was damaged and the balls
Electronics Forum | Wed Mar 27 02:59:01 EST 2002 | ianccy
Hi, Don't know if some holes can be drilled to yur machine table, if so, yu can make the support with at least 2 pin and plug into the table, better to use aluminium support, easier to CNC. Hope this help
Electronics Forum | Thu Jun 22 15:05:55 EDT 2017 | solderingpro
There are several different technologies in the industry today to assist in the out-gassing of flux cores. On automated soldering systems, there are two main types of perforating solder feeders: - Hole Drilling - "V" Scoring By perforating the so
Electronics Forum | Thu Sep 09 09:13:10 EDT 1999 | Scott Cook
| hi, i m college student. i m currently doing my Final year project in PCB drilling. the main task is to design auto feeder which allign the PCB properly in position before drilling take place. the close tolerance becomes a big problem to the precis
Electronics Forum | Fri Sep 10 09:03:52 EDT 1999 | ScottM
| | hi, i m college student. i m currently doing my Final year project in PCB drilling. the main task is to design auto feeder which allign the PCB properly in position before drilling take place. the close tolerance becomes a big problem to the prec
Electronics Forum | Wed Sep 02 20:18:18 EDT 2015 | sarason
Are your PCB's stretched or is it that the films that were used to make your PCB's distorted.Thus vias and TH's don't align. These things will probably be picked up in bare board testing , but depending on the amount of offset may get through, to yo
Electronics Forum | Sun Sep 12 08:20:04 EDT 1999 | se
| | | | hi, i m college student. i m currently doing my Final year project in PCB drilling. the main task is to design auto feeder which allign the PCB properly in position before drilling take place. the close tolerance becomes a big problem to the
Electronics Forum | Sat Feb 12 08:13:48 EST 2005 | pemnut
I have seen BEC holes drilled wrong also. On a couple of products We run, We insert a Pem Nut. The insertion hole is too large for BEC to read. So We have the board house drill a small hole for each array, circuit. If these smaller holes are drilled
Electronics Forum | Fri Sep 10 12:09:02 EDT 1999 | Earl Moon
| | | hi, i m college student. i m currently doing my Final year project in PCB drilling. the main task is to design auto feeder which allign the PCB properly in position before drilling take place. the close tolerance becomes a big problem to the pr